LG DLGX8388NM Owner's Manual - Page 21
Optional Accessories - stack
View all LG DLGX8388NM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
OPTIONAL ACCESSORIES PEDESTAL INSTALLATION (cont.) 3 Make sure the side surface of the appliance is clean and dry. Remove paper backing from the tape on the bracket. 4 Position the bracket as shown. The bent part of the bracket should rest along the edge of the pedestal, and the holes in the bottom part of the bracket should align with the holes in the pedestal. 5 Install 2 screws to securely attach the bracket to the pedestal. Once properly attached, firmly press the top part of the bracket with the double-sided tape to the side of the appliance. Repeat steps 3-5 to attach the other brackets. NOTE: If the brackets are not installed properly, noise and vibration may result. Be sure to remove paper backing and to use all screws to install the brackets. Move the appliance to the desired location. 40 Raise Lower 6 Loosen the locknuts on all 4 leveling feet of the pedestal until you can turn them with the wrench. Turn clockwise to raise or counterclockwise to lower. Once the pedestal is level and all 4 feet are solidly against the floor, securely tighten all locknuts by hand. NOTE: Noise and vibration may result if locknuts are not tightened. Be sure to connect the appliances to all water, power, or gas lines and draining or venting connections before operation. If there is excessive vibration during the first operation after installation, slightly adjust the leveling feet. OPTIONAL ACCESSORIES STACKING KIT INSTALLATION This stacking kit includes: •Two (2) side rails •One (1) front rail •Four (4) screws Tools Needed for Installation: • Phillips-head screwdriver To ensure safe and secure installation, please observe the following instructions. wWARNING • Incorrect installation can cause serious accidents. • The weight of the dryer and the height of installation make this stacking procedure too risky for one person. Two or more people are required when installing the stacking kit. There is a risk of serious back injury or other injuries. • Do not use the stacking kit with a gas dryer in potentially unstable conditions such as a mobile home. Failure to follow this warning can result in serious injury. • Place the washer on a solid, stable, level floor capable of supporting the weight of both appliances. Failure to follow this warning can result in serious injury. • If appliances are already installed, disconnect them from all power, water, or gas lines and from draining or venting connections. Failure to do so can result in electrical shock, fire, explosion, or death. 1 Make sure the surface of the washer is clean and dry. Remove paper backing from the tape on one of the stacking kit side brackets. 2 Fit the side bracket to the side of the washer top as shown in the above illustration. Firmly press the adhesive area of the bracket to the washer surface. Secure the side bracket to the washer with a screw on the back side of the bracket. Repeat steps 1 and 2 to attach the other side bracket. 41