LG DU-60PY10 Owners Manual - Page 16

Installation CableCARDTTMM Setup How to use Insert the CableCARDTTMM received from Cable Service provider to CableCARDTTMM slot of TV back panel. If Host or CableCARDTTMM does not display on the screen, contact with Cable service provider by phone. Note : • CableCARDTTMM has the types of Motorola, Scientific Atlanta, SCM etc.. These 3 types of CableCARDTTMM can be used for this PLASMA TV. Caution: When removing the CableCARDTTMM, do not fall it as this may cause impact to the CableCARDTTMM. Cable ANTENNA CABLE AC INPUT HDSTB Setup - This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below. - This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i). HDMI / DVI(VIDEO) AUDIO INPUT DIGITAL AUDIO(OPTICAL) DVI COMPONENT2 VIDEO INPUT Cable ANTENNA CABLE AC INPUT or or RGB-DTV OUTPUT (R) AUDIO (L) or (R) AUDIO (L) DIGITAL AUDIO OPTICAL DVI-DTV OUTPUT HDMI-DTV OUTPUT or DIGITAL AUDIO OPTICAL (R) AUDIO (L) B R Digital Set-top Box How to connect Use the TV's COMPONENT (Y, PB, PR) INPUT, RGB or HDMI/DVI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections. How to use 1. Turn on the digital set-top box. (Refer to the owner's manual for the digital set-top box.) 2. Use TV/VIDEO or COMP/RGB/HDMI on the remote control to select Component 1, Component 2, RGB-DTV, or HDMI/DVI source. Signal 480i 480p 720p 1080i Component 1/2 Yes Yes Yes Yes RGB-DTV,HDMI/DVI No Yes Yes Yes 16 Plasma TV