LG HBM-800 User Manual - Page 5

How to use Headset Call waiting* - Answer a second call without hanging up the first call by pressing the CALL button for 1 second. Press the CALL button for 1 second to return to the original call. - Briefly press the CALL button to terminate the active call or both calls at once. (subject to handset's support) Call Reject* - Activate Call Reject by pressing the CALL button for 1 second when the headset rings. * It is possible to use these functions only when your handset supports them. For further information about using these features, please consult your handset's user manual. Multipoint The LG HBM-800 is capable of having two handsets connected to the Headset at the same time. This will give you the freedom of having only one Headset to operate both of your handsets. Multipoint Connect - Pair the Headset with one of your Bluetooth-enabled handsets. (Refer to the pairing instructions on pages 5-6). - Turn off the Headset. - With the power off, press and hold the PWR button on the HBM-800 for 5 seconds to enter Manual Pairing mode. - Now, pair and connect the Headset with your other Bluetooth-enabled handset. (This will be your Primary handset). - Once this handset is paired and connected, go back and connect the first paired handset to Headset. (This process should be done through your handset's Bluetooth menu) * Note: When the HBM-800 is connected to two handsets at the same time (Multipoint), the Headset calling functions will work with the most recently used handset. Calling Functions - Voice Dial and Last Number Redial features work with the Primary handset. (most recently used handset). - The first connected device is set as primary handset and the next connected device is set as secondary handset. - The device which made the last outgoing call will always be set as the primary handset. 8 How to use Headset - To answer an incoming call on your secondary handset, while on a call on your primary handset, hang-up the active-call (briefly press the CALL button) and then answer the incoming-call (briefly press the CALL button again). Sun Visor Clip How to use Cradle Charging - Remove the cover on the charging port and connect the charger. - The LED indicator will show a solid red light. - It takes 2 hours to fully charge the Cradle. - When charging is complete, the LED indicator will turn off. Low battery - A low battery tone will play once every 30 seconds. - If the battery is not charged, the Cradle will turn off. Power on - Press and Hold the MFB for 3 seconds. �The power will turn on and a booting tone will play. Power off - Press and hold the MFB for 3 seconds. Volume control - Press the VOLUME UP or VOLUME DOWN button to adjust the speaker volume. - There are eight levels of speaker volume. - You will hear an alert tone when the volume is at the maximum or minimum level. 9