LG LP6000ER Owners Manual - Page 6
Remote Control Operations - air conditioners
View all LG LP6000ER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Operating Instructions Remote Control Operations The remote control and control panel will look like those represented in the following pictures. 1 6 3 AIR PURIFIER Air Purifier Power 1 Temp 2 Fan Speed 4 Timer Mode 5 3 Timer Auto Swing 4 2 5 Remote Control Operations 1 POWER • To turn the air conditioner ON, push this button. To turn the air conditioner OFF, push the button again. • This button takes priority over any other button. • When you first turn it on, the unit is in cool mode, high fan speed, temperature setting at 72˚F. 2 TEMPERATURE SETTING • Use this button to automatically control the temperature of the room. The temperature can be set within a range of 60°F to 86°F by increments of 1°F. 3 MODE - Every time you push this button, it will cycle through the following modes: COOL, ENERGY SAVER, FAN and DRY. - ENERGY SAVER • The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will turn on and the unit will check the room air to determine if cooling is needed. 4 FAN SPEED • Every time you push this button, it advances the setting as follows: {High(F3) ¡ Low(F1) ¡ Med(F2) ¡ High(F3)} 5 TIMER - SHUT-OFF TIME • You will usually use shut-off time while you sleep. • With unit running, use Timer to set number of hours until shut-off. • For your sleeping comfort, once Time is set, the Temperature setting will raise 2°F after 30 min, and 2°F after another 30 min. • Every time you push Timer button, it advances the Timer setting as follows: 1 Hour ¡ 2 Hours ¡ etc. ¡ 12 Hours maximum. - START TIME • With unit not running, use timer to set number of hours before unit starts. • Every time you push Timer button, it advances the Timer setting as follows: 1 Hour ¡ 2 Hours ¡ etc. ¡ 12 Hours maximum. 6 REMOTE CONTROL SENSOR AUTO RESTART When power is restored after an electrical power failure, the unit will begin to run at its last setting. 6