LG LRSDS2706D Owners Manual - Page 16

Assembling the Freezer Door

Get LG LRSDS2706D PDF manuals and user guides View all LG LRSDS2706D manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

16 INSTALLATION NOTE • The number of wire harnesses may vary depending on the model. • Ground wire is only present on some models. 4 Push the water supply lines into the hole on the top case and pull them through the backplate. Assembling the Freezer Door 1 Install the freezer door onto the bottom hinge pin a. NOTE • The number of wire harnesses may vary depending on the model. • Ground wire is only present on some models. 2 Fit the hinge b over the hinge lever latch c and slot it into place. Rotate the lever d clockwise and fasten the hinge. 5 Hold the water supply connection and gently push in the collet e to connect the water supply lines as shown. Insert the tube at least 5/8 inch (15 mm) into the connector. Insert the clip on the joint to fasten the tubes in place. NOTE • Align the freezer door with the cabinet to help fit the top hinge in place. NOTE • Disassembling/Assembling the Water Lines 3 Connect all the wire harnesses and the ground wire. f Collet g Tube h Insert line i Clip

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
16
INSTALLATION
NOTE
•
The number of wire harnesses may vary
depending on the model.
•
Ground wire is only present on some models.
Assembling the Freezer Door
1
Install the freezer door onto the bottom hinge
pin
a
.
2
Fit the hinge
b
over the hinge lever latch
c
and slot it into place. Rotate the lever
d
clockwise and fasten the hinge.
NOTE
•
Align the freezer door with the cabinet to help fit
the top hinge in place.
3
Connect all the wire harnesses and the
ground wire.
4
Push the water supply lines into the hole on
the top case and pull them through the
backplate.
NOTE
•
The number of wire harnesses may vary
depending on the model.
•
Ground wire is only present on some models.
5
Hold the water supply connection and gently
push in the collet
e
to connect the water
supply lines as shown. Insert the tube at least
5/8 inch (15 mm) into the connector. Insert
the clip on the joint to fasten the tubes in
place.
NOTE
•
Disassembling/Assembling the Water Lines
f
Collet
g
Tube
h
Insert line
i
Clip