LG LSFXC2476S Owners Manual - Page 12
Removing/Assembling the, Freezer Drawer Handle, Doors and Drawers
View all LG LSFXC2476S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 INSTALLATION Removing/Assembling the Freezer Drawer Handle Removing the Handles 1 Loosen the set screws located on the lower side of the handle with a 1/8 in. Allen wrench and remove the handle. 2 Loosen the mounting fasteners that connect to the freezer drawer and handle using a 1/4 in. Allen wrench, and remove the mounting fasteners. Assembling the Handles 1 Assemble the mounting fasteners at both ends of the handle using a 1/4 in. Allen wrench. 2 Place the handle on the door by fitting the handle footprints over the mounting fasteners and tightening the set screws with a 1/8 in. Allen wrench. Removing/Assembling the Doors and Drawers When it is necessary to move the refrigerator through a narrow opening, removing the doors is the recommended procedure. Warning yy If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator doors and move the refrigerator sideways through the doorway. yy Use two or more people to remove and install the refrigerator doors. Failure to do so can result in back or other injury. yy Disconnect the electrical supply to the refrigerator before installing. Failure to do so could result in serious injury or death. yy Do not put hands, feet or other objects into the air vents or bottom of the refrigerator. You may be injured or receive an electrical shock. yy Be careful when handling the hinge and stopper, to avoid injury. yy Remove food and bins before detaching the doors and drawers. Tools Needed Flat-head screwdriver 10 mm or 13/32 in. socket wrench Phillips screwdriver Warning When assembling or disassembling the handle: yy Grasp the handle tightly to avoid dropping it. yy Do not swing the handle into nearby people or animals. yy Make sure that the bracket hole of the handle fits properly into the stopper bolt of the door. Assemble the set screws to fix the handle into place. yy Make sure that there is not a gap between the door and handle after assembling the handle.