LG LSFXC2476S Owners Manual - Page 47

Replacing the water filter causes a small

Page 47 highlights

ENGLISH MAINTENANCE 47 1 Remove the old water filter. Lower or remove the top left shelf to allow the water filter to rotate all the way down. Press the push button to open the water filter cover. NOTE: Replacing the water filter causes a small amount of water (around 1 oz. or 25 cc) to drain. Place a cup under the front end of the water filter cover to collect any leaking water. Hold the water filter upright, once it is removed, to prevent any remaining water from spilling out of the water filter. Pull the water filter downward and pull out. Make sure to rotate the filter down completely before pulling it out of the manifold hole. 2 Replace with a new water filter. Take the new water filter out of its packing and remove the protective cover from the o-rings. With the water filter tabs in the horizontal position, push the new water filter into the manifold hole until it stops. 3 After the water filter is replaced, dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air and contaminants from the system. Do not dispense the entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF. 4 Water Filter Bypass Plug Keep the water filter bypass plug. You MUST use the water filter bypass plug when a replacement water filter cartridge is not available. Water Filter Bypass Plug Caution DO NOT operate refrigerator without water filter or water filter plug installed. Note yy To purchase a replacement water filter: Visit your local dealer or distributor Web: Find Parts & Accessories from Support section of lg.com Call : 1-800-243-0000 (USA) 1-888-542-2623 (Canada) yy Part number of the replacement water filter: ADQ36006101 Rotate the water filter up into position and close the cover. The cover will click when closed correctly.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66

47
MAINTENANCE
ENGLISH
2
Replace with a new water filter.
Take the new water filter out of its packing
and remove the protective cover from the
o-rings. With
the water
filter tabs in
the horizontal
position, push
the new water
filter into the
manifold hole
until it stops.
Rotate the water filter up
into position and close
the cover. The cover
will click when closed
correctly.
3
After the water filter is replaced,
dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove
trapped air and contaminants from the
system. Do not dispense the entire 2.5
gallon amount continuously. Depress and
release the dispenser pad for cycles of 30
seconds ON and 60 seconds OFF.
4
Water Filter Bypass Plug
Keep the water
filter bypass plug.
You MUST use
the water filter
bypass plug when a
replacement water
filter cartridge is not
available.
Water Filter
Bypass Plug
CAUTION
DO NOT operate refrigerator without
water filter or water filter plug installed.
NOTE
To purchase a replacement water filter:
y
Visit your local dealer or distributor
Web: Find Parts & Accessories from
Support section of lg.com
Call : 1-800-243-0000 (USA)
1-888-542-2623 (Canada)
Part number of the replacement water
y
filter: ADQ36006101
1
Remove the old water filter.
Lower or remove
the top left shelf to
allow the water filter
to rotate all the way
down.
Press the push button
to open the water
filter cover.
NOTE:
Replacing the water filter causes a small
amount of water (around 1 oz. or 25 cc) to drain.
Place a cup under the front end of the water
filter cover to collect any leaking water.
Hold the
water filter upright, once it is removed, to prevent
any remaining water from spilling out
of the water filter.
Pull the water filter
downward and pull
out. Make sure to
rotate the filter down
completely before
pulling it out of the
manifold hole.