LG LSFXC2476S Owners Manual - Page 24
Leveling and Door Alignment
View all LG LSFXC2476S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
24 INSTALLATION Leveling and Door Alignment Leveling After installing, plug the refrigerator's power cord into a 3-prong grounded outlet and push the refrigerator into the final position. Your refrigerator has two front leveling legs- one on the right and one on the left. Adjust the legs to alter the tilt from front-to-back or sideto-side. If your refrigerator seems unsteady, or you want the doors to close more easily, adjust the refrigerator's tilt using the instructions below: Door Alignment The left refrigerator door has an adjustable nut, located on the bottom hinge, to raise and lower the door for proper alignment. If the space between your doors is uneven, follow the instructions below to align the doors evenly: Use the wrench (included with the Use & Care Guide) to turn the nut in the door hinge to adjust the height. To the right to raise or to the left to lower the height. 1 Turn the leveling leg to the left to raise that side of the refrigerator or to the right to lower it. It may take several turns of the leveling leg to adjust the tilt of the refrigerator. Note A flare nut wrench works best, but an open-end wrench will suffice. Do not over-tighten. 2 Open both doors again and check to make sure that they close easily. If the doors do not close easily, tilt the refrigerator slightly more to the rear by turning both leveling legs to the left. It may take several more turns, and you should turn both leveling legs the same amount. The right refrigerator door does not have an adjustable nut. If the space between your doors is uneven, follow the instructions below to align the right door: 1 With one hand, lift up both the inner and outer door sections of the right door to raise them at the middle hinge. (Opening the door may make lifting it easier) 2 With the other hand, use pliers to insert the snap ring on the middle hinge of the inner door section as shown. Do not insert the ring on the hinge of the outer door section. 3 Insert additional snap rings until the right door is aligned. (Two snap rings are provided with the unit.) Outer Inner Door Door