LG LSSB2692ST Owners Manual - Page 32

Care and Maintenance Troubleshooting Guide COOLING Before conducting troubleshooting, make sure that the following basic requirements are met: Service Flow Water Supply Water Pressure Operating Ambient Temperature Limits Electrical Ratings 0.5 gpm (1.9 lpm) Potable Water 20-120 psi (138 - 827 kPa) 33°F - 100°F (0.6 °C - 38 °C) 115 Volts, 60 Hz, AC only, and fused at 15 or 20 amperes. Problem Refrigerator and Freezer section are not cooling. Possible Causes The refrigerator control is set to OFF (some models). Refrigerator is set to demo mode. Refrigerator is in the defrost cycle. Refrigerator was recently installed. Refrigerator was recently relocated. Solutions Turn the control ON. Refer to the Setting the Controls section for proper temperature settings. Demo Mode allows the lights and control display to work normally while disabling cooling to save energy while on the showroom floor. Refer to the Setting the Controls section for instructions on how to disable Demo Mode. During the defrost cycle, the temperature of each compartment may raise slightly. Wait 30 minutes and confirm the proper temperature has been restored once the defrost cycle has completed. It may take up to 24 hours for each compartment to reach the desired temperature. If the refrigerator was stored for a long period of time or moved on its side, it is necessary for the refrigerator to stand upright for 24 hours before connecting it to power. 31