LG LSSB2692ST Owners Manual - Page 40

Icemaker is not, making ice., Problem, Possible Causes, Solutions

Page 40 highlights

Care and Maintenance Problem Icemaker is not making ice. Possible Causes Refrigerator was recently installed or icemaker recently connected. Icemaker not turned on. The ice detecting sensor is obstructed. The refrigerator is not connected to a water supply or the supply shutoff valve is not turned on. Icemaker shutoff (arm or sensor) obstructed. Reverse osmosis water filtration system is connected to your cold water supply. Solutions It may take up to 24 hours for each compartment to reach the desired temperature and for the icemaker to begin making ice. Locate the icemaker on/off switch and confirm that it is in the ON (I) position. Foreign substances or frost on the icedetecting sensor can interrupt ice production. Make sure that the sensor area is clean at all times for proper operation. Connect refrigerator to the water supply and turn the water shutoff valve fully open. If your icemaker is equipped with an ice shutoff arm, make sure that the arm moves freely. If your icemaker is equipped with the electronic ice shutoff sensor, make sure that there is a clear path between the two sensors. Reverse osmosis filtration systems can reduce the water pressure below the minimum amount and result in icemaker issues. (Refer to the Water Pressure section.) 39

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53

Care and Maintenance
39
Refrigerator was recently installed
or icemaker recently connected.
Icemaker not turned on.
The ice detecting sensor is
obstructed.
The refrigerator is not connected to
a water supply or the supply shutoff
valve is not turned on.
Icemaker shutoff (arm or sensor)
obstructed.
Reverse osmosis water filtration
system is connected to your cold
water supply.
It may take up to 24 hours for each
compartment to reach the desired
temperature and for the icemaker to begin
making ice.
Locate the icemaker on/off switch and
confirm that it is in the ON (I) position.
Foreign substances or frost on the ice-
detecting sensor can interrupt ice
production. Make sure that the sensor area
is clean at all times for proper operation.
Connect refrigerator to the water supply and
turn the water shutoff valve fully open.
If your icemaker is equipped with an ice
shutoff arm, make sure that the arm moves
freely. If your icemaker is equipped with the
electronic ice shutoff sensor, make sure that
there is a clear path between the two
sensors.
Reverse osmosis filtration systems can
reduce the water pressure below the
minimum amount and result in icemaker
issues. (Refer to the Water Pressure
section.)
Icemaker is not
making ice.
Problem
Possible Causes
Solutions