LG LSXC22426S Owners Manual - Page 19

NOTE: To make adjusting the legs easier, have someone push backward against the top of the refrigerator. Height di erence Height di erence C CHANGE FILTER F C PRESS & HOLD F Right leveling leg 2 Open both doors again and check to make sure that they close easily. If the doors do not close easily, tilt the refrigerator slightly more to the rear by turning both leveling legs counterclockwise. It may take several more turns. Be sure to turn both leveling legs the same amount. Door Alignment If the doors are still uneven after the refrigerator has been leveled, nish adjusting the doors by following the instructions below: Tools Required: 5/16" (8mm) wrench and 3/4" (19mm) wrench. Height di erence Height di erence C CHANGE FILTER F C PRESS & HOLD F 1 keeper nut 2 Adjustment hinge pin Down Up 3 Tool for adjustment INSTALLATION 19 Using a 3/4" (19mm) wrench, turn the keeper nut counter clock wise to loosen it. Using a 5/16" (8mm) wrench, turn the adjustment hinge pin clockwise or counterclockwise to level the refrigerator door. After leveling the door, turn the keeper nut clockwise to tighten it. CAUTION Do not overtighten the door adjustment screw. The hinge pin can be pulled out (adjustable range of height is a maximum of 2 in. (5cm). Turning on the Power 1 Plug in the refrigerator. CAUTION Connect to a rated power outlet. Have a electrician check the wall outlet and wiring for proper grounding. Do not damage or cut o the ground terminal of the power plug. Position the Refrigerator Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back toward the wall. Start the Icemaker If the water line is connected, set the icemaker power switch to the ON position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (-9°C) or below. It will then begin operation automatically if the icemaker power switch is in the ON (|) position. ENGLISH