Lenovo IdeaCentre K200 K200 Hardware Replacement Guide - Page 17
Replacing the heat sink assembly
View all Lenovo IdeaCentre K200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Replacing the heat sink assembly Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://www.lenovo.com/support. To replace the heat sink assembly: 1. Remove the computer cover. Refer to "Removing the computer cover". 2. Lay the computer on its side. 3. Locate the heat sink. Refer to "Identifying parts on the system board". 4. Disconnect the heat sink and the fan assembly cable from the system board. 5. Remove the four screws securing the heat sink and fan assembly to the system board. 6. Lift the failing heat sink and fan assembly off the system board. 7. Use the thermal grease syringe to place five drops of grease on the top of the microprocessor. Each drop of grease should be 0.03ml (3 tick marks on the grease syringe). Hardware Replacement Guide 15 31032753 IdeaCentre K_HRG_EN.indd 15 2007.12.7 3:41:55 PM