Lenovo NetVista Hardware Maintenance Manual for NetVista 2289 and 6824 systems - Page 10
Power, APM BIOS Mode, Disabled, Automatic Power
View all Lenovo NetVista manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
If NO, continue to 002 . If YES, proceed to 003 . 002 If the Power Management feature is enabled, do the following: 1. Start the Configuration/Setup Utility program (see "Setup Utility program" on page 12) 2. Select Power from the Configuration/Setup Utility program menu. 3. Be sure APM BIOS Mode is set to Disabled. If it is not, press Space Bar to change the setting. 4. Select Automatic Power On. 5. Set Automatic Power On to Disabled. 6. If the problem persists, continue to 003 . 003 Run the Diagnostic programs. If necessary, refer to "Diagnostics" on page 14. v If you receive an error, replace the part that the diagnostic program calls out or go to ″Symptom-to-FRU Index″ on page 41. v If the test stops and you cannot continue, replace the last device tested. 4 Hardware Maintenance Manual