Lenovo Q200 Q200 Hardware Maintenance Manual - Page 32

Replacing a memory module

Get Lenovo Q200 PDF manuals and user guides View all Lenovo Q200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 32 highlights

Hardware Maintenance Manual 4. Refer to the "Completing the installation". Replacing a memory module Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com. To replace a memory module: 1. Open the computer cover. Refer to "Opening the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Pivot the drive bay assembly upward to gain access to the system board. 3. Locate the memory module connectors. Refer to "Locating components". 4. Remove the memory module being replaced by opening the retaining clips as shown. 5. Position the new memory module over the memory connector. Make sure the notch on the memory aligns correctly with the connector key on the system board. Push the memory module straight down into the connector until the retaining clips close. 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
Hardware Maintenance Manual
30
4.
Refer to the “Completing the installation”.
Replacing a memory module
Attention
Do not remove the computer cover or attempt any repair before
reading the “Important safety information” in the
Safety and Warranty
Guide
that was included with your computer or in the
Hardware
Maintenance Manual
(HMM) for the computer. To obtain copies of
the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at
To replace a memory module:
1.
Open the computer cover. Refer to “Opening the computer cover”.
Note:
For this procedure, it helps to lay the computer on its side.
2.
Pivot the drive bay assembly upward to gain access to the system
board.
3.
Locate the memory module connectors. Refer to “Locating
components”.
4.
Remove the memory module being replaced by opening the retaining
clips as shown.
5.
Position the new memory module over the memory connector. Make
sure the notch
on the memory aligns correctly with the connector
key
on the system board. Push the memory module straight down
into the connector until the retaining clips close.