Lenovo Q200 Q200 Hardware Maintenance Manual - Page 40

Notes, Important, To avoid damaging the microprocessor contacts, do not tilt the, microprocessor

Get Lenovo Q200 PDF manuals and user guides View all Lenovo Q200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

Hardware Maintenance Manual Notes a. Note the orientation of the notches on the microprocessor. This is important when reinstalling the microprocessor on the new system board. b. Do not drop anything onto the microprocessor socket while it is exposed. The socket pins must be kept as clean as possible. 16. On the new system board, release the lever securing the microprocessor retainer and then pivot the retainer until it is fully open. Note: There will be a black plastic cover on the microprocessor retainer to protect the socket on the new system board. Remove the black plastic cover and place it on the microprocessor socket of the failing system board. 17. Holding the microprocessor with your fingers, position the microprocessor so that the notches on the microprocessor are aligned with the tabs in the microprocessor socket. Important To avoid damaging the microprocessor contacts, do not tilt the microprocessor when installing it into the socket. 18. Lower the microprocessor straight down into the system board socket of the new system board. 19. To secure the microprocessor in the socket, close the microprocessor retainer and lock it into position with the small handle. 20. Install the retention module for the heat sink and fan assembly on the system board. 38

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
Hardware Maintenance Manual
38
Notes
a. Note the orientation of the notches
on the microprocessor. This
is important when reinstalling the microprocessor on the new
system board.
b. Do not drop anything onto the microprocessor socket while it is
exposed. The socket pins must be kept as clean as possible.
16. On the new system board, release the lever securing the
microprocessor retainer and then pivot the retainer until it is fully
open.
Note:
There will be a black plastic cover on the microprocessor retainer
to protect the socket on the new system board. Remove the black
plastic cover and place it on the microprocessor socket of the failing
system board.
17. Holding the microprocessor with your fingers, position the
microprocessor so that the notches on the microprocessor are aligned
with the tabs in the microprocessor socket.
Important
To avoid damaging the microprocessor contacts, do not tilt the
microprocessor when installing it into the socket.
18. Lower the microprocessor straight down into the system board socket
of the new system board.
19. To secure the microprocessor in the socket, close the microprocessor
retainer and lock it into position with the small handle.
20. Install the retention module for the heat sink and fan assembly on the
system board.