Lenovo Q200 Q200 Hardware Maintenance Manual - Page 37
Replacing the system board
View all Lenovo Q200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Chapter 7. Replacing hardware Replacing the system board 1. Turn off the computer and allow the computer to cool for one hour. 2. Open the computer cover. Refer to the "Opening the computer cover". 3. Pivot the drive bay assembly upward to gain access to the system board. 4. While pressing the release button to lift the adapter latch and remove the adapter by pulling it straight out of the adapter connector. 5. Carefully take note of the location of all cable connections on the system board. It will be necessary to reconnect them properly when installing a new system board. Important Note the cable routing. It is important to route the cables the same way after you install the new system board. 6. Disconnect all cables connected to the system board. Refer to the "Identifying parts on the system board". 7. Remove the screws that secure the system board to the chassis. 8. Lift the system board out of the chassis carefully. Note: You might have to tilt the front end of the system board between the diskette drive and the fan assembly to remove it completely from the chassis. 35