Lenovo ThinkPad 390X Hardware Maintenance Manual (November 1999): ThinkPad 390 - Page 47
Error Messages, No Beep Symptoms
View all Lenovo ThinkPad 390X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Error Messages Symptom/Error FRU/Action in Sequence Device Address Conflict 1. Load Setup Defaults in BIOS Setup Utility. 2. Backup battery (RTC) 3. System board Allocation Error for: device 1. Load Setup Defaults in BIOS Setup Utility. 2. Backup battery (RTC) 3. System board Failing Bits: nnnn 1. DIMM 2. BIOS ROM 3. System board Invalid System Configuration Data 1. Load Setup Defaults in BIOS Setup Utility. 2. BIOS ROM 3. System board I/O device IRQ conflict 1. Load Setup Defaults in BIOS Setup Utility. 2. Backup battery (RTC) 3. System board Operating system not found 1. Enter BIOS Setup Utility and see if the hard disk drive and diskette drive A: are properly identified. 2. Diskette drive 3. Hard disk drive 4. System board Critical battery low Save your work; then connect the AC Adapter to the computer to recharge the battery. ERROR EDO RAM exist, system halt! Non PC100 SDRAM exist, system halt! 1. DIMM 2. System board No Beep Symptoms Symptom/Error FRU/Action in Sequence No beep, power-on indicator on, LCD blank, no POST Ensure every connector is connected tightly and correctly. DIMM Reseat CPU card. CPU card System board ThinkPad 390X / i 1700 HMM 41