Lenovo ThinkPad E555 (English) Hardware Maintenance Manual - Page 53
Beep symptoms, LCD-related symptoms, Important, Notes
View all Lenovo ThinkPad E555 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Beep symptoms Table 4. Beep symptoms Symptom or error One short beep, pause, three short beeps, pause, three more short beeps, pause, and one short beep One long and two short beeps Five short beeps FRU or action, in sequence 1. Replace the memory module. 2. Replace the system board. Replace the system board. Replace the system board. No-beep symptoms Table 5. No-beep symptoms Symptom or error No beep, power-on indicator on, LCD blank, and no POST. No beep, power-on indicator on, and LCD blank during POST. The power-on password prompt appears. The hard-disk password prompt appears. FRU or action, in sequence 1. Ensure that every connector is connected tightly and correctly. 2. Reseat memory module. 3. Replace the system board. 1. Reseat memory module.. 2. Replace the system board. A power-on password or a supervisor password is set. Type the password and press Enter. A hard-disk password is set. Type the password and press Enter. LCD-related symptoms Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT LCD technology, but excessive pixel problems can cause viewing concerns. If the LCD you are servicing has two or less visible defective pixels, it should not be considered faulty. However, if the LCD has three or more visible defective pixels, it will be deemed as defective by Lenovo and it should be replaced. Notes: • This policy applies to all ThinkPad Notebooks purchased on 1 January, 2008 or later. • Lenovo will not provide warranty replacement if the LCD is within specifications because we cannot guarantee that any replacement LCD will have zero pixel defects. • One pixel consists of R, G, B sub-pixels. Table 6. LCD-related symptoms Symptom or error No beep, power-on indicator on, and a blank LCD during POST. • LCD backlight not working. • LCD too dark. • LCD brightness cannot be adjusted. • LCD contrast cannot be adjusted. FRU or action, in sequence Replace the system board. 1. Reseat the LCD connectors. 2. Replace the LCD assembly. 3. Replace the system board. Chapter 4. Related service information 47