Home » Lenovo Manuals » Laptops » Lenovo ThinkPad i Series 1300 » Manual Viewer

Lenovo ThinkPad i Series 1300 English - Windows Me Setup Guide - Page 38

Models, Issue, Cause, Resolution, Resolution

Get Lenovo ThinkPad i Series 1300 PDF manuals and user guides

View all Lenovo ThinkPad i Series 1300 manuals

Add to My Manuals
Save this manual to your list of manuals

Page 38 highlights

2.5 The system may hang at the boot time when the PCI IRQ steering is changed from 11 (default value) to 9 Models: Issue: Cause: Resolution: ThinkPad 600X When the user changes the value of PCI IRQ Steering to 9 from 11(default value) with the ThinkPad Utility in order to use the IDE device in SelectaDockII/III, the system hangs at boot time. Under investigation. This problem occurs only when Windows Me is clean installed on the system It does not occur when Windows Me is installed during an upgrade. When the user encounters this problem, please change the value of PCI IRQ Steering back to 11. If you still want to use the IDE device in Docking, please change the assignment of IDE device by ThinkPad Utility as below: Primary Master → Internal HDD Primary Slave → IDE devices in the Ultra Slim Bay (CD ROM or other IDE devices) Secondary Master/Slave → For IDE device in Docking To configure above IDE configuration, follow the following step. 1. Open ThinkPad configuration by double-clicking the icon in Systray. 2. Click DeviceBay -> Disable Warm Swap deices -> Apply -> OK 3. Reboot the system. 2.6 16-bit PC Cards hot plugged to the dock PC Card slot will not be detected after warm docking with an ATA PC Card already installed in the PC Card slot of the dock. Models: Issue: Resolution ThinkPad 390 When the ATA PC Card is already installed in the docking PC Card slot, the system will not detect any 16-bit PC Card device when it's hot plugged on the docking PC Card slot when the device driver is not installed prior to Warm Dock. Cold dock the system with 32-bit PC Card device in the dock PC Card slot.. 1. Shut down the System 2. Insert 32-bit PC Card device in the dock PC Card slot 3. Power on the System 4. The system should detect the new devices 5. Once the device driver is installed, the device will be detected every time its cold/hot/warm docked. 3 PC Cards and Device Support 3.1 PCMCIA Card Services yellow "!" with Code (1) - Not configured correctly Models: Issue: All ThinkPad Models When any PC Card device is installed, the OS detects it and installs the PCMCIA Card Services. When PC Card device is hot plugged for

Section	Page
Introduction	4
Supported Windows Me ThinkPad Models	5
Before Installing or Upgrading to Windows Me	7
“Preparation”	8
“Update Computer”	9
Updating the ThinkPad system BIOS for Windows Me	9
Downloading Device Drivers for Post install or upgrade	11
	11
	11
	11
ThinkPad model 240 series and 390 series device drivers list	11
“Pre-Setup”	14
Section 1: Creating the Startup Diskette (Clean Install)	14
Section 2: Uninstalling or upgrading the unsupported applications and device drivers (Upgrade Install)	14
“Installing or Upgrading to Windows Me”	18
Section 1: Installing Windows Me (Clean Install)	18
Section 2: Upgrading to Windows Me (Upgrade Install)	20
“Post Setup”	22
Section1: Installing Device Drivers (Clean Install)	22
To Install DVDExpress on your ThinkPad for Windows Me	23
Section 2: Installing and Upgrading Device Drivers (Upgrade Install)	25
To upgrade Video (NeoMagic MagicMedia 128AV/256AV) to Windows Me built-in driver (ThinkPad 240)	26
To upgrade Video (NeoMagic MagicGraph 128ZV+) to Windows Me built-in driver (ThinkPad i Series 1400 2611-410/450/411/451)	27
To upgrade Audio (Ess Solo1) to Windows Me built-in driver (ThinkPad models 240, 390E, 390X, i Series 2611-412/452/472/512/552, i Series 2621, i Series 2651)	27
To upgrade Audio (Crystal SoundFusion) to Windows Me built-in driver (ThinkPad models 570, 570E, 600X, A20m, A20p and T20)	27
To upgrade Audio (Crystal SoundFusion) to Windows Me built-in driver (ThinkPad models 600 and 600E)	28
General Technical Information	29
Docking Station/Port Replicator support for supported ThinkPad models	29
Tips for docking station support on ThinkPad models 570 and 570E:	30
Tips for docking station support on ThinkPad models 600, 600E and 600X:	31
Tips for docking station support on ThinkPad models A20m, A20p, T20 and X20:	31
Hot and Warm swapping support for supported ThinkPad models	31
UltraBay FX device swapping with ThinkPad models 390, 390E and 390X:	31
UltraslimBay device swapping with ThinkPad models 570 and 570E:	32
UltraslimBay device swapping with ThinkPad models 600, 600E and 600X:	32
Ultrabay 2000 device swapping with ThinkPad T20:	32
Ultrabay 2000 device and UltraBase X2 swapping with ThinkPad X20:	32
Ultrabay 2000 device swapping with ThinkPad models A20m and A20p:	33
Windows Me Hints and Tips	34
Power Management	34
Power Meter Icon located on SysTray (by default, this is in the lower right corner) does not update automatically from AC to Battery mode or vice versa	34
Wake-On Ring (WOR) needs to be enabled in the Power Option for ThinkPad 570 and 600 Series	34
OS Hibernation on APM system is not supported	34
Standby triggered by closing the lid is not supported if any PC Card device is installed.	34
The Screen flashes with random characters and patterns for a while when resuming from Hibernation mode.	35
Windows Media Player changes to window screen mode when using Power Management.	35
Standby is not available if select USB printers are installed.	35
USB Wake Up is not supported	36
Fn + F3 key to turn off LCD monitor does not work when playing Windows Media Player.	36
System cannot hibernate when using video camera	36
System cannot hibernate with some USB cameras	36
HDD power off timer does not work intermittently on battery mode	36
Docking Station/Port Replicator	36
Ring Central Fax cannot receive fax data when docked and in Standby mode	36
System makes a clicking sound when starting Windows Me and the system is docked to SelectaDock III.	37
The wheel scroll function on some USB mice does not work after hot docking.	37
Some USB hubs or USB devices properties show green (?) mark	37
The system may hang at the boot time when the PCI IRQ steering is changed from 11 (default value) to 9	38
16-bit PC Cards hot plugged to the dock PC Card slot will not be detected after warm docking with an ATA PC Card already installed in the PC Card slot of the dock.	38
PC Cards and Device Support	38
PCMCIA Card Services yellow “!” with Code (1) - Not configured correctly	38
Adaptec SlimSCSI 1480A PC Card causes system hang	39
Some PC cards might not be detected after resuming from Standby mode.	39
IBM Token Ring PC Card driver is not included in Windows Me.	39
ATA PC Card does not work.	39
Video/Multimedia	41
A version conflict message appears when updating IBM supplied NeoMagic Video driver (NMG5) over the built-in NeoMagic Video driver (NMG5) in Windows Me.	41
After playing MPEG file by Windows Media Player, the color mode of the screen does not resume correctly when using Dual Display.	41
Windows Media Player v.7.0 cannot play two or more multimedia files simultaneously	41
CD Audio volume Control does not work during playing CD Audio on Windows Media Player	41
Graphics on Windows Media Player stops (freezes) when Windows Media Player is running in full screen mode	42
Windows Media Player pull down menu does not display in 256-color mode when the movie is playing.	42
Volume Control setting change is not restored when the system reboots.	42
3D function of Y-Station does not work under Windows Me	42
No subtitle on DVD after resuming from Standby mode with some DVD movies	43
Device Configuration and Setup	43
“Crystal SoundFusion Joystick’ device will be marked with a yellow ”!” in the Device Manager when docked.	43
Two Infrared Communication Device will appear after upgrade if the Infrared device is not enabled.	43
Red X mark in USB Serial Port with IBM USB Multiple Hub.	43
Communication	43
Limitation to Ring Central Voice after upgrading to Windows Me.	44
NetBEUI connection is lost when resuming from standby or hibernation.	44
IBM Global Network Dialer	45
When transferring a file using the Infrared device at 4 Mbps from a computer running Windows Me to computer running Windows 98, the file transfer fails	45
Ring Central sometimes fails to receive the file after wake up from RI.	45
Upgrade and installation Issues	45
Touching Trackpoint causes a hang during clean install	45
Short Cut Key Window will appear during upgrade install	46
Windows Me cannot be set up with OS/2 Boot Manager	46
Access ThinkPad displays an error message after upgrading from Windows 98 to Windows Me	46
Miscellaneous	46
Norton Antivirus Version 4.08 is not supported	46

Match case Limit results 1 per page

2.5

The system may hang at the boot time when the PCI IRQ steering is changed

from 11 (default value) to 9

Models:

ThinkPad 600X

Issue:

When the user changes the value of PCI IRQ Steering to 9 from

11(default value) with the ThinkPad Utility in order to use the IDE

device in SelectaDockII/III, the system hangs at boot time.

Cause:

Under investigation.

This problem occurs only when Windows Me is

clean installed on the system

It does not occur when Windows Me is

installed during an upgrade.

Resolution:

When the user encounters this problem, please change the value of

PCI IRQ Steering back to 11.

If you still want to use the IDE device

in Docking, please change the assignment of IDE device by ThinkPad

Utility as below:

Primary Master

→

Internal HDD

Primary Slave

→

IDE devices in the Ultra Slim Bay (CD ROM or

other IDE devices)

Secondary Master/Slave

→

For IDE device in Docking

To configure above IDE configuration, follow the following step.

1. Open ThinkPad configuration by double-clicking the icon in

Systray.

2. Click DeviceBay -> Disable Warm Swap deices -> Apply -> OK

3. Reboot the system.

2.6

16-bit PC Cards hot plugged to the dock PC Card slot will not be detected

after warm docking with an ATA PC Card already installed in the PC Card slot

of the dock.

Models:

ThinkPad 390

Issue:

When the ATA PC Card is already installed in the docking PC Card

slot, the system will not detect any 16-bit PC Card device when it’s

hot plugged on the docking PC Card slot when the device driver is not

installed prior to Warm Dock.

Resolution

Cold dock the system with 32-bit PC Card device in the dock PC Card

slot..

Shut down the System

Insert 32-bit PC Card device in the dock PC Card slot

Power on the System

The system should detect the new devices

Once the device driver is installed, the device will be detected

every time its cold/hot/warm docked.

PC Cards and Device Support

3.1

PCMCIA Card Services yellow “!” with Code (1) - Not configured correctly

Models:

All ThinkPad Models

Issue:

When any PC Card device is installed, the OS detects it and installs

the PCMCIA Card Services.

When PC Card device is hot plugged for