Lexmark 11C0200 Service Manual - Page 72

Jam 201 The paper has stopped at the synchronizing roller, or has not reached the exit roller. FRU 1 Fuser Sensor (PC9) Synchronizing Roller • Synchronizing Solenoid (SL2) • Mechanical Controller Board • Image Transfer Roller • Image Transfer Solenoid • Image Transfer Sensor (PC2) Transport Belts Fuser Assembly Action Go to the "Sensor Service Check" on page 2-47 and check the fuser sensor (PC9) and actuator. If it is working correctly, return to this check. Check the synchronizing/timing roller for dirt or wear. Clean or replace as necessary. If the synchronizing/timing roller does not rotate, replace the synchronizing solenoid or the mechanical controller board. 2 3 4 If paper is stopped at the image transfer roller, check the roller for dirt or wear and clean or replace as necessary. Check the image transfer solenoid for correct operation. The image transfer roll should be lifted when paper is passing over it. 5 6 Check the transport belts for damage and replace if necessary. Check the fuser belts and the fuser lower roller for wear or damage. If it is not operating correctly, replace the fuser assembly. This is a customer replaceable part at prescribed intervals. Diagnostic Information 2-37