Lexmark C750 Setup Guide - Page 51
Verifying the IPsettings, Configuring for PullPrinting
View all Lexmark C750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
6 Change the address by pressing Menu to increase or decrease each number. Press Select to move to the next segment. Press Select when you are finished. The message Saved appears briefly. 7 Press Menu until you see Set IP Netmask, and then press Select. 8 Repeat step 6 to set the IP Netmask. 9 Press Menu until you see Set IP Gateway, and then press Select. 10 Repeat step 6 to set the IP Gateway. 11 When you are finished, press Go to return the printer to the Ready state. Verifying the IP settings Note: On Windows computers, click Start Programs Command Prompt. 1 Print another network setup page. Look under the "TCP/IP" heading and make sure the IP address, netmask, and gateway are what you expected. See "Printing a network setup page" on page 42 if you need help. 2 Ping the printer and verify that it responds. For example, at a command prompt on a network computer type "ping" followed by the new printer IP address: ping xxx.xxx.xxx.xx If the printer is active on the network, you should receive a reply. Configuring for Pull Printing If your printer has an optional ImageQuick firmware card installed, it can be configured for Pull Printing once an IP address has been assigned. For detailed configuration instructions, refer to the CD that shipped with the ImageQuick card. Configure for TCP/IP 45