Lexmark OptraImage 242 OptraImage 242/232 Setup Guide (2.5 MB) - Page 12
Step 6, Turn on scan unit and printer
View all Lexmark OptraImage 242 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Step 6: Turn on scan unit and printer First time setup Power up sequence 1 If you are using a MarkNet N2501e, plug the telephone fax line cable into the phone line outlet. 2 If you disconnected the Ethernet network cable from the print server in a previous step, reconnect it. 3 Plug in the scan unit power cord. THE SCAN UNIT AUTOMATICALLY TURNS ON. 4 Plug the printer power cord into a properly grounded outlet and turn on the printer. 5 If you turned off the power to your computer in a previous step, turn the power back on. 6 Wait for OptraImage to initialize. When the scan unit comes on, there is a short wait cycle while the firmware is initialized. "Please Set Date/Time" displays on the first line of the OptraImage control panel and "Please Wait..." displays on the second line. Do not turn off the printer or unplug the scan unit until the "Please Wait..." message disappears from the control panel. OptraImage panel: Please Set Date/Time Please Wait . . . When initialization is completed, the Please wait message disappears. The Please Set Date/Time prompt indicates that you need to set required fax information. Restart OptraImage Panel: Please Wait . . . Printer panel Printer panel: 24MB of memory required for Fax. . . When you restart OptraImage, a Please wait message displays on the second line of the control panel. When initialization is completed the OptraImage control panel displays the current time and date, plus the Ready status message. When you first turn on your printer, you may see the message on the left. The Analog Fax option is disabled unless an upgrade of memory to a total of at least 24MB is performed. Hardware setup is now complete. You are ready to configure OptraImage. 12 OptraImage Setup Guide