Lexmark T654 Service Manual - Page 86
Sensor pass through
View all Lexmark T654 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
4062 Error code or message 243.35 243.36 243.37 243.39 243.40 243.49 243.50 Error contents Pick page received while POR not yet done. Source = Tray 3 Sensor (pass through) static jam Source = Tray 3 Sensor (pass through) late jam Source = Tray 3 Media tray pulled jam Source = Tray 3 Sensor (pass through) lingering jam Source = Tray 3 HCIT tray lift motor stalled failure Source = Tray 3 HCIT tray lift motor underspeed failure Source = Tray 3 Description/Action Media remains on the sensor (input) during the warm up sequence. Media remains on the sensor (input) during the warm up sequence. The media is late reaching the sensor (pass through) within the specified time. A media tray above the source tray was pulled during the printing process. Media reached the sensor (pass through) within the specified time but did not clear it within the specified time. The HCIT tray lift motor has stalled or has become obstructed. The HCIT tray lift motor does not rotate at the specified speed. Possible repair actions Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-147. Go to sensor (pass through) static jam service check. See "Sensor (pass through) static jam service check" on page 2-147. Go to sensor (pass through) late jam service check. See "Sensor (pass through) late jam service check" on page 2-145. 1. Remove all media present in media path. 2. Close all media trays. Go to sensor (pass through) lingering jam service check. See "Sensor (pass through) lingering jam service check." on page 2-146. 1. Ensure the HCIT media tray assembly is properly inserted into the machine. 2. Check the HCIT tray lift motor assembly for binding or damage. 3. Replace the HCIT tray lift drive motor assembly if problem remains. Go to "High capacity input tray (HCIT) tray lift drive motor assembly removal" on page 4-125. 1. Ensure the HCIT media tray assembly is properly inserted into the machine. 2. Check the HCIT tray lift motor assembly for binding or damage. 3. Replace the HCIT tray lift drive motor assembly if problem remains. Go to "High capacity input tray (HCIT) tray lift drive motor assembly removal" on page 4-125. 2-52 Service Manual