LiftMaster 3265 3265M Manual - Page 26

OPERATION, Using Your Garage Door Opener - 5 blinks

Page 26 highlights

OPERATION IMPORTANT SAFETY INSTRUCTIONS WARNING To reduce the risk of SEVERE INJURY or DEATH: 1. READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS. 9. If one control (force or travel limits) is adjusted, the other control may also need adjustment. 2. ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with garage door control push buttons or remote controls. 10. After ANY adjustments are made, the safety reversal system MUST be tested. 11. Safety reversal system MUST be tested every month. Garage door MUST reverse on contact with 3. ONLY activate garage door when it can be seen clearly, it is properly adjusted, and there are no obstructions to door travel. 1-1/2" (3.8 cm) high object (or a 2x4 laid flat) on the floor. Failure to adjust the garage door opener properly may cause SEVERE INJURY or DEATH. 4. ALWAYS keep garage door in sight until completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR. 5. NO ONE SHOULD GO UNDER A STOPPED, PARTIALLY OPEN DOOR. 6. If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly, causing SEVERE INJURY or DEATH. 12. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). An improperly balanced door may NOT reverse when required and could result in SEVERE INJURY or DEATH. 13. ALL repairs to cables, spring assemblies and other hardware, ALL of which are under EXTREME tension, MUST be made by a trained door systems technician. 14. ALWAYS disconnect electric power to garage door opener BEFORE making ANY repairs or removing covers. 7. NEVER use emergency release handle unless garage doorway is clear of persons and 15. SAVE THESE obstructions. 8. NEVER use handle to pull garage door open or INSTRUCTIONS. closed. If rope knot becomes untied, you could fall. Using Your Garage Door Opener 6. If obstructed while opening, the door will stop. Your Security✚® opener and hand-held remote control have been factory-set to a matching code which changes with each use, randomly accessing over 100 billion new codes. Your opener will operate with up to eight Security✚® remote controls and one Security✚® Keyless Entry System. If you purchase a new remote, or if you wish to deactivate any remote, follow the instructions in the Programming section. Activate your opener with any of the following: • The hand-held Remote Control: Hold the large push button down until the door starts to move. • The wall-mounted Door Control: Hold the push button or bar down until the door starts to move. • The Keyless Entry (See Accessories): If provided with your garage door opener, it must be programmed before use. See Programming. When the opener is activated (with the safety 7. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle. If the sensor is not installed, or is misaligned, the door won't close from a hand-held remote. However, you can close the door with the Door Control, the Outside Keylock, or Keyless Entry, if you activate them until down travel is complete. If you release them too soon, the door will reverse. The opener lights will turn on under the following conditions: when the opener is initially plugged in; when power is restored after interruption; when the opener is activated. They will turn off automatically after 4-1/2 minutes or provide constant light when the Light feature on the Multi-Function Door Control is activated. Bulb size is A19. Bulb power is 100 watts maximum. Security✚® light feature: Lights will also turn on when reversing sensor correctly installed and aligned) someone walks through the open garage door. With a 1. If open, the door will close. If closed, it will open. Multi-Function Door Control, this feature may be turned 2. If closing, the door will reverse. off as follows: With the opener lights off, press and hold 3. If opening, the door will stop. the light button for 10 seconds, until the light goes on, 4. If the door has been stopped in a partially open then off again. To restore this feature, start with the position, it will close. opener lights on, then press and hold the light button for 5. If obstructed while closing, the door will reverse. 10 seconds until the light goes off, then on again. If the obstruction interrupts the sensor beam, the opener lights will blink for five seconds. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

26
OPERATION
Using Your Garage Door Opener
Your Security
®
opener and hand-held remote control
have been factory-set to a matching code which changes
with each use, randomly accessing over 100 billion
new codes. Your opener will operate with up to eight
Security
®
remote controls and one Security
®
Keyless
Entry System. If you purchase a new remote, or if you
wish to deactivate any remote, follow the instructions in
the
Programming
section.
Activate your opener with any of the following:
The hand-held Remote Control:
Hold the large push
button down until the door starts to move.
The wall-mounted Door Control:
Hold the push
button or bar down until the door starts to move.
The Keyless Entry (See Accessories):
If provided with
your garage door opener, it must be programmed
before use. See
Programming.
When the opener is activated (with the safety
reversing sensor correctly installed and aligned)
1.
If open, the door will close. If closed, it will open.
2.
If closing, the door will reverse.
3.
If opening, the door will stop.
4.
If the door has been stopped in a partially open
position, it will close.
5.
If obstructed while closing, the door will reverse.
If the obstruction interrupts the sensor beam, the
opener lights will blink for five seconds.
6.
If obstructed while opening, the door will stop.
7.
If fully open, the door will not close when the beam
is broken. The sensor has no effect in the opening
cycle.
If the sensor is not installed, or is misaligned, the door
won’t close from a hand-held remote. However, you
can close the door with the Door Control, the Outside
Keylock, or Keyless Entry,
if you activate them until
down travel is complete.
If you release them too soon,
the door will reverse.
The opener lights
will turn on under the following
conditions: when the opener is initially plugged in; when
power is restored after interruption; when the opener is
activated.
They will turn off automatically after 4-1/2 minutes or
provide constant light when the Light feature on the
Multi-Function Door Control is activated. Bulb size is
A19. Bulb power is 100 watts maximum.
Security
®
light feature:
Lights will also turn on when
someone walks through the open garage door. With a
Multi-Function Door Control, this feature may be turned
off as follows: With the opener lights off, press and hold
the light button for 10 seconds, until the light goes on,
then off again. To restore this feature, start with the
opener lights on, then press and hold the light button for
10 seconds until the light goes off, then on again.
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
WARNING
WARNING
1.
READ AND FOLLOW ALL WARNINGS
AND INSTRUCTIONS.
2.
ALWAYS keep remote controls out of reach of
children. NEVER permit children to operate or play
with garage door control push buttons or remote
controls.
3.
ONLY activate garage door when it can be seen
clearly, it is properly adjusted, and there are no
obstructions to door travel.
4.
ALWAYS keep garage door in sight until
completely closed. NO ONE SHOULD CROSS THE
PATH OF THE MOVING DOOR.
5.
NO ONE SHOULD GO UNDER A STOPPED,
PARTIALLY OPEN DOOR.
6.
If possible, use emergency release handle to
disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly, causing SEVERE INJURY
or DEATH.
7.
NEVER use emergency release handle unless
garage doorway is clear of persons and
obstructions.
8.
NEVER use handle to pull garage door open or
closed. If rope knot becomes untied, you could fall.
9. If one control (force or travel limits) is adjusted,
the other control may also need adjustment.
10. After ANY adjustments are made, the safety
reversal system MUST be tested.
11.
Safety reversal system MUST be tested every
month. Garage door MUST reverse on contact with
1-1/2" (3.8 cm) high object (or a 2x4 laid flat) on
the floor. Failure to adjust the garage door opener
properly may cause SEVERE INJURY or DEATH.
12.
ALWAYS KEEP GARAGE DOOR PROPERLY
BALANCED (see page 3). An improperly balanced
door may NOT reverse when required and could
result in SEVERE INJURY or DEATH.
13. ALL repairs to cables, spring assemblies and
other hardware, ALL of which are under EXTREME
tension, MUST be made by a trained door
systems technician.
14.
ALWAYS disconnect electric power to garage door
opener BEFORE making ANY repairs or removing
covers.
15.
SAVE THESE
INSTRUCTIONS.