LiftMaster 3265 3265M Manual - Page 27

Using the Wall-Mounted Door Control THE MULTI-FUNCTION DOOR CONTROL Press the push button to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening. Push Button Lock Button Light feature Press the Light button to turn Light Button the opener light on or off. It will not control the opener lights when the door is in motion. If you turn it on and then activate the opener, the light will remain on for 4-1/2 minutes. Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes. B) To operate one door using all three buttons on the hand-held remote: You may program the remote to open the door with the large button, close it with the middle button, and stop the door's movement with the third button. Open Close Stop NOTE: If remote is already programmed, you must first erase all codes. See Programming. 1. With the door closed, press and hold the large remote push button. 2. Press and hold the Lock button on the door control. 3. Press and hold the door control push bar. 4. After the opener lights flash, release all buttons. To Open the Door Manually Lock feature Designed to prevent operation of the door from hand-held remote controls. However, the door will open and close from the Door Control, the Outside Keylock and the Keyless Entry Accessories. To activate, press and hold the Lock button for 2 seconds. The push bar light will flash as long as the Lock feature is on. To turn off, press and hold the Lock button again for 2 seconds. The push bar light will stop flashing. The Lock feature will also turn off whenever the "learn" button on the motor unit panel is activated. To prevent possible SERIOUS INJURY or DEATH from a falling garage door: • If possible, use emergency release handle to disengage trolley ONLY when garage door is CLOSED. Weak or broken springs or unbalanced door could result in an open door falling rapidly and/or unexpectedly. • NEVER use emergency release handle unless garage doorway is clear of persons and obstructions. • NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall. Additional features when used with the 3-Button hand-held remote The door should be fully A) To control the opener lights: closed if possible. Pull In addition to operating the door, you may program the remote to operate the lights. 1. With the door closed, press and hold a small remote button that you want to control the light. 2. Press and hold the Light button on the down on the emergency release handle and lift the door manually. To Emergency reconnect the door to the Release Handle Trolley Release Arm opener, press the door (Pull Down) control push bar. MANUAL DISCONNECT POSITION Multi-Function door control. 3. While holding the Light button, press and hold the Lock button on the door control. The lockout feature prevents the trolley from reconnecting automatically. 4. After the opener lights flash, release all buttons. Pull the emergency release handle down and back (toward the opener). The door can then be raised and lowered manually as often as necessary. To Emergency Release Handle Trolley Release Arm disengage the lockout (Down and Back) feature, pull the handle straight down. The trolley LOCKOUT POSITION will reconnect on the next UP or DOWN operation, either manually or by using the door control or remote. 27