LiftMaster 8587WL Owners Manual - English French Spanish - Page 18
Wire the Door Control to the Garage Door Opener, Attach the Warning Labels
View all LiftMaster 8587WL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Install the Door Control 2 Wire the Door Control to the Garage Door Opener PRE-WIRED INSTALLATIONS: When wiring the door control to the garage door opener make sure you use the same wires that are connected to the door control. 1. Run the white and red/white wire from the door control to the garage door opener. Attach the wire to the wall and ceiling with staples (not applicable for gang box or pre-wired installations). Do not pierce the wire with the staple as this may cause a short or an open circuit. 2. Strip 7/16" (11 mm) of insulation from the end of the wire near the garage door opener. 3. Connect the wire to the red and white terminals on the garage door opener. To insert or release wires from the terminal, push in the tab with screwdriver tip. 1 2 7/16" (11 mm) Staple 3 Attach the Warning Labels 1. Attach the entrapment warning label on the wall near the door control with tacks or staples. 2. Attach the manual release/safety reverse test label in a visible location on the inside of the garage door. 3 RED WHITE WHITE GREY 18