LiftMaster HS670 HS670 GL BOARD Manual - Page 8

OPERATOR WARNINGS SAFETY PRECAUTIONS FOR OPEN ROLLER GATES AND ORNAMENT "GRILL TYPE" GATES WARNING • Injuries occur when people get their hands or feet caught CAUTION between the top or bottom of the gate and the gate roller. These potential pinch-points should be guarded against at all times. Enclosed style gate tracks are available for refitting of these rollers from many fence suppliers. Also, roller guards are available for installing over the rollers. • UL325 requires that, when used, contact sensors shall be located at the leading edge, trailing edge, and be post mounted both inside and outside of a vehicular horizontal slide gate. Non-contact sensors such as photo eyes must protect during both open and close gate cycles. • Injuries occur when people put their hands and arms through openings in the grill while the gate is operating. They cannot retract their arm and it gets caught between the moving gate grill and the stationary fence post or fence. This AVERTISSEMENT potential hazard can be averted by placing a 4' screen mesh on the gate to prevent access through openings anywhere the gate may travel. See Safety Brochure for details. To prevent entrapment injuries, mount controls at least 6' ATTENTION from the gate or any moving parts of the gate. Gate Edge on Rear of Gate for Open Direction Gate Edge on Fence Post for Open Direction Gate Edge on Leading Edge of Gate for Close Direction WARNING Photo Beam for Open Direction UNIT Additional Post Mounted Gate Edge for Close Direction Pinch-Point Hazard Photo Beam for Close Direction WARNING Additional Post Mounted Gate Edge for Open Direction Always Test Gate Edges and Photo Beams Anytime They Are Adjusted or Serviced Gate Edge Pinch-Point Hazard Gate Edge for AVERTISSEMENT Gate Edge for Open Direction Close Direction Vertical Post Placed on AVERTISSEMENT Both Sides of the Exposed Rollers Can Prevent Hands From Reaching These Pinch-Points Open Gate Edge Open Gate Edge Gate Edge for Close Direction OR Close Photo Beam OR Unit Open Photo Beam WARNING SIGN PLACEMENT ADWVEARRTNEINNGCIA To prevent SERIOUS INJURY or DEATH from a moving gate: PRCEACUATUIOCINÓN • Install Warning signs on EACH side of gate in PLAIN VIEW. • Permanently secure each Warning sign in a suitable manner using fastening holes. • Do NOT mount accessories that are accessible through gate. NOT FOR USE AS PEDESTRIAN PASSAGE! This operator is intended for vehicular use only. To prevent INJURY to pedestrians, a separate pedestrian access should be supplied, visible from the gate. Locate the pedestrian access where there is not a chance of INJURY at any point during full movement of the gate. 8 AVERTISSEMENT ADWVEARRTNEINNGCIA ADWVAERRTNEINNGCIA Moving Gate Can Cause Injury or Death KEEP CLEAR! Gate may move at any time without prior warning. Do not let children operate the gate or play in the gate area. This entrance is for vehicles onl.y Pedestrians must use separate entrance AVERTISSEMENT