LiftMaster RSL12U RSL12U Installation Manual - Page 46

ACCESSORIES MISCELLANEOUS REMOTE ANTENNA EXTENSION KIT The remote antenna extension kit allows the antenna to be remotely installed. Model 86LM COMMERCIAL ACCESS CONTROL RECEIVER Access control receiver for up to 1,000 devices (any combination of remote controls and wireless keyless entries). Model STAR1000 PLUG-IN LOOP DETECTOR Conveniently plugs into existing control board. Model LOOPDETLM MISCELLANEOUS LIFTMASTER® INTERNET GATEWAY Internet enabled accessory which connects to the computer and allows you to monitor and control gate operators and lighting accessories enabled by MyQ® technology. Model 828LM EXPANSION BOARD Additional programming features including external loops, plug-in loops, auxiliary relays, and inputs for additional controls and entrapment protection devices. Model K1D8387-1CC WIRE HARNESS Between main control board and expansion board. Model K94-34778 LOOP DETECTOR Low power loop detectors mounted and wired separately inside control box. LiftMaster low power accessory. Model LD7LP VEHICLE SENSING PROBE The vehicle sensing probe is buried in the ground and can detect a car as it approaches and will then open the gate. Model CP3 MOUNTING STAND For Model RSL Slide. Ideal to raise slide operator higher above the ground for snow and other applications. Model MSLM WIRELESS COMMERCIAL KEYPAD Durable wireless keypad with blue LED backlight metal keypad, zinc-alloy metal front cover and 5 year 9V lithium battery. Security+ 2.0® compatible. Model KPW250 SOLAR PANEL KIT This kit is to replace or add a solar panel to the operator application. 60W maximum for 24 Vdc operators and 30W maximum for 12 Vdc operators. Requires a 33AH battery harness. Models SOLPNL10W12V (10 Watt, 12V), SP10W12V* (10 Watt, 12V) and SP20W12V* (20 Watt, 12V) MAGNETIC GATE LOCK Outdoor magnetic lock, transformer, junction box, mounting plate and hardware. Not for use with Solar Applications. Must be powered separately. Model MG1300 HEATER The heater keeps the gearbox and batteries at a suitable temperature when the outside temperature is below -4°F. The thermostat MUST be set between 45°F and 60°F to ensure proper gate operation. The heater can be powered by 110 to 250 Vac. Model HTR BATTERIES Gate access system batteries replace or upgrade the gate operator batteries. One 12 Vdc battery is required for each gate operator. Do not mix 7AH and 33AH batteries within a gate operator. 7AH BATTERIES Standard 7 AMP-Hour Battery, 12 Vdc, to replace original battery provided with operator. Reuse existing harnesses. Models 29-NP712 (1) and K74-30762 (2) 33AH BATTERIES Upgrade 33 AMP-Hour Battery, 12 Vdc. Ideal for solar applications. Model A12330SGLPK 33AH BATTERY HARNESS Required for 33AH applications. Model K94-37236 * Available end of 2015 45