LiftMaster TLS1CARD Owners Manual - English - Page 9
Sp Mode 1
View all LiftMaster TLS1CARD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
SP MODE 1 SP (SPECIAL MODES) MODE 1 This mode allows a second set of external, track mounted limits to act as primary or backup for the operator's open, close, and safety limits. The position of these limits can be set either before or after the operator's limits. This mode would be used in lieu of previous modification 90-42104. NOTE: It is not required that all three inputs have a switch connected to the TLS1CARD. Either the external close, external safety, external open, or all three may be used. 1 Disconnect power to the operator. 2 Turn DIP switches 1, 3, and 4 on the TLS1CARD to the ON position. DIP switch 2 should remain OFF. SP MODE 1 DIP SWITCH SETTINGS O1 2 3 4 N 3 Connect the auxiliary device(s) to the input and output terminals on the TLS1CARD as described below. Outputs: • Connect a red light to the R1 terminals on the TLS1CARD. This will signal that the external close limit switch has been activated. • Connect a green light to the R2 terminals on the TLS1CARD. This will signal that the external open limit switch has been activated. • Connect a yellow light to the R3 terminals on the TLS1CARD. This will signal that the external safety limit switch has been activated. Required Inputs: • Connect external CLOSE limit switch common and normally open contacts to the COMMON (#10) and FD/SIS (#11) terminals on the TLS1CARD respectively. • Connect external OPEN limit switch common and normally open contacts to the COMMON (#10) and T/TS (#12) terminals on the TLS1CARD respectively. • Connect external SAFETY limit switch common and normally open contacts to the COMMON (#10) and SIC (#9) terminals on the TLS1CARD respectively. External Open Limit External Safety Limit External Close Limit R1 LED OFF OFF ON R2 LED ON OFF OFF R3 LED OFF ON OFF NOTE: Relay LEDs R1, R2, and R3 on the TLS1CARD will turn ON at the same time as relays R1, R2, and R3. SP MODE 1 (TYPICAL CONNECTION) 6 R3 5 T/TS 12 FD/SIS 11 INPUTS (RELAYS) OUTPUTS 4 R2 3 COMMON 10 SIC 9 2 R1 1 SIO 8 COMMON 7 5 A, 230 Vac, 30 Vdc Dry Contact Only TLS1CARD Timer Light Status Option Card 40-35757-1 * External Track Mount Limit Switch *OLS *CLS *SLS After configurations and connections have been made for your card mode proceed to Installation page 10. 9