Linksys FENSK05-CA User Guide - Page 19

Linksys EtherFast® Series 6. The adapter will be added to the list of installed Network Adapters. Click Next. 10/100 Network In a Box 8. A list of services will appear. Click Next to approve these services, followed by Next again. 7. Place check marks beside each listed network protocol that you wish to install. See your Microsoft Windows NT user guide or talk to your network administrator for more information about network protocols. When you're finished, click Next. Note: If you install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation when installation steps that aren't listed in this User Guide appear. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol. 9. NT will probably ask you to supply your original Windows NT CD-ROM or setup disks. If so, place your Windows NT CD-ROM in your CD drive. If the CD-ROM loads a pop-up window, close it. Type D:\i386 (or the appropriate CD-ROM drive letter) in the box and click Continue. 10. NT will ask you to choose a media type for the EtherFast card. Choose AutoSense. You can change these settings later if needed. When finished, click OK. 32 33