Linksys FENSK05-CA User Guide - Page 6

Linksys EtherFast® Series Installing the EtherFast 10/100 LAN Card Overview Each EtherFast 10/100 LAN Card is equipped with an RJ-45 port that automatically adjusts to either 10Mbps or 100Mbps speeds, allowing your PC to attach to either Fast Ethernet (also known as 100BaseTX) or regular 10BaseT Ethernet network segments without additional hardware or software. The card should only be used with twisted-pair cabling. 10BaseT and 100BaseTX cabling is available in a number of different grades. For best results, we recommend using 8-wire, category 5 unshielded twisted-pair for both 10BaseT and 100BaseTX network segments, although category 3 can be used for 10BaseT segments. The cable that runs from your PC's EtherFast card to your network should not exceed 100 meters (328 feet). Both Category 3 and 5 twisted-pair cabling can be purchased at most computer stores, or if you prefer, you can crimp your own cables. See page 67 for wiring information. Installing the Network Card & Cabling 1. Power off your PC and any peripheral equipment attached to it. Unplug your PC's power cord. 2. Remove your computer's outside cover. 3. Open your computer and locate the PCI slot(s) on your motherboard. PCI slots are easily identified by their beige or white color, and by the fact that network cards fit snugly into them. Remove the metal slot cover on the back of the PC, then insert the EtherFast 10/100 LAN Card into a PCI card slot, as shown in the photograph on the next page (top). Note: Some network cards might need a 4. If you are interested in Wake-On-LAN, you can go to page 61 now. Wake-On-LAN can be installed at any time, so there is no need to do it now. If you don't know what Wake On LAN bit of muscle to be installed. Our network cards are built strongly, and are hard to break. Avoid a call to tech- is, or if you know that you don't want to use WOL, proceed to step 5 on the next page and return to WOL later. nical support by making sure that your card is inserted all the way into your PC's network slot! 6 10/100 Network In a Box 5. Once your EtherFast EtherFast 10/100 LAN Card is firmly in place, secure its fastening tab to your PC's chassis with a mounting screw. 6. Replace your PC's cover. 7. Connect one end of a twisted-pair cable to your PC at the EtherFast 10/100 LAN Card's RJ-45 port. 8. Plug the other end of the cable into your 5-Port Hub. 7