Linksys PCM200 User Guide - Page 19

Linksys Instant EtherFast® Series 6. NT will then display a window containing several setting types. Keep the default settings unless you know that you need to change them. EtherFast® 10/100 CardBus PC Cards After you have made the appropriate settings, click OK. 7. NT will probably ask you to supply your original Windows NT CD-ROM or setup disks. Direct Windows NT to the proper location (e.g., D:\i386). Click Continue. 8. Click on the Protocols tab. Add any protocols you require by clicking the Add button. 9. After your bindings, settings, and services are set, click the Close button. 10. Remove your Driver Disk and click Yes to restart your PC. Note: If you install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation when installation steps that aren't listed in this User Guide appear. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol. 32 11. Once your PC has rebooted, double-click the Network Neighborhood icon on your desktop. Ensure that you have access to the network. If you do, you card has been properly installed. • If you had previously installed any NT service packs, you must go back and re-install those service packs now. If you need to install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol The Windows NT EtherFast Card Installation and Setup is complete. 33