Lowrance HDS-9 Gen3 Operators Manual US - Page 97
: Autopilot, Safe operation with the autopilot, Switching from automatic navigation to standby mode
View all Lowrance HDS-9 Gen3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
14 Autopilot If a MotorGuide Xi5 trolling motor with Pinpoint GPS is connected to the network, then the SmartSteer (autopilot) functionality is available on your HDS Gen3. To use trolling motor autopilot functionality, you need the following: • MotorGuide Xi5 trolling motor with Pinpoint GPS (available from MotorGuide) • MotorGuide Pinpoint GPS Gateway (available from MotorGuide) • NMEA 2000® network. For details about installing this equipment, refer to the separate installation manuals that come with the equipment. The Autopilot can automatically control the trolling motor to: • Maintain a set heading • Maintain the vessel's position • Navigate to the cursor position, to a waypoint, or along a route • Follow pre-defined turn patterns Xi5 trolling motor software You may have to update the software in the MotorGuide Xi5 trolling motor to use it with the Lowrance SmartSteer interface. If an update is necessary, a Trolling motor update dialog appears on your networked HDS unit(s). The update process is initiated through an HDS unit. Follow the onscreen instructions to update Xi5 software. Safe operation with the autopilot Warning: An autopilot is a useful navigational aid, but DOES NOT replace a human navigator. Switching from automatic navigation to standby mode To switch from autopilot to handheld remote or foot pedal steering, set the autopilot to standby mode. You can select standby mode from the Autopilot Controller or the System Controls dialog. Autopilot | HDS Gen3 Operator Manual 97