Mackie 2404-VLZ4 Owners Manual - Page 30
TRS Send/Receive Insert Jacks, Using the Send Only on an Insert Jack
View all Mackie 2404-VLZ4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
TRS Send/Receive Insert Jacks Using the Send Only on an Insert Jack Single-jack inserts are three-conductor, TRS-type 1⁄4" phone. They are unbalanced, but have both the mixer output (send) and the mixer input (return) signals in one connector. See the illsutration below. The sleeve is the common ground (earth) for both signals. The send from the mixer to the external unit is carried on the tip, and the return from the unit to the mixer is on the ring. ring tip sleeve (TRS plug) SEND to processor tip This plug connects to one of the mixer's Channel Insert jacks. ring RETURN from processor Unbalanced 1/4" Insert Connectors If you insert a TS (mono) 1⁄4" plug only partially (to the first click) into a VLZ4 insert jack, the plug will not activate the jack switch and will not open the insert loop in the c ircuit (thereby allowing the channel signal to continue on its merry way through the mixer). This allows you to tap out the channel or bus signal without interrupting normal operation. If you push the 1⁄4" TS plug in to the second click, you will open the jack switch and create a d irect out, which does interrupt the signal in that channel. See the illustration below. NOTE: Do not overload or short-circuit the signal you are tapping from the mixer. That will affect the internal signal. MONO PLUG Channel Insert jack Direct out with no signal interruption to master. Insert only to first click. MONO PLUG Channel Insert jack Direct out with signal interruption to master. Insert all the way in to the second click. STEREO PLUG Channel Insert jack For use as an effects loop. (Tip = Send TO effect, Ring = Return FROM effect). Using the Send Only on an Insert Jack 30 VLZ4 4•Bus