Magic Chef MCD991ARB User Manual - Page 8

INSTALLATION 1. Examine the oven after unpacking. Check for damage such as a misaligned door, broken door or dent in the cavity. If any damage is visible, DO NOT INSTALL, and notify your dealer immediately. 2. Level, flat location. Install the microwave oven on a level, flat surface. 3. Ventilation. Do not block air vents. If they are blocked during operation, the oven may overheat and eventually cause a failure. For proper ventilation, allow 3 inches of space between oven top, sides, rear and adjacent surfaces. 4. Away from radio and TV sets. Poor television reception and radio interference may result if the oven is located close to a TV, radio, antenna, feeder, etc. Place the oven as far from them as possible. 5. Away from heating appliances and water taps. Keep the oven away from heat, steam or splashing liquids. These things can adversely affect oven wiring and contacts. 6. Power supply. • Check your local power source. This microwave oven requires a current of approximately 12.5 amperes, 120Volts, 60Hz grounded outlet. 1. A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord. 2. Longer cord sets or extension cords are available and may be used if care is exercised in their use. 3. If a long cord or extension cord is used: • The marked electrical rating of the cord set or extension cord should be at least as great as the electrical rating of the appliance. • The extension cord must be a grounding type 3-wire cord. • The longer cord should be arranged so that it will not drape over the counter top or tabletop where it can be pulled on by children or tripped over unintentionally. 7. The minimum height of free space necessary above the top surface of the oven is about 4 inches. When use 3-pronged plug 3-prong Receptacle 0 0 0 0 3-prong plug Receptacle Box cover When use grounding adaptor, make sure the receptacle box is fully grounded. Grounding Lead O 0 0 Receptacle Box Cover Grounding Receptacle Adaptor THE CANADIAN ELECTRICAL CODE DOES NOT ALLOW THE USE OF THE GROUNDING ADAPTOR" 7