Magnavox D-60ES / Owners Manual - Page 4

DEHUMIDIFIER CONTROL PANEL 10 Display Shows the set % humidity level from 35% to 85% or auto start/stop time (0~24) while setting, then shows the actual ( 5% accuracy) room % humidity level in a range of 30% RH(Relative Humidity) to 90%RH(Relative Humidity). Error Codes and Protection Code: AS- Humidity sensor error--Unplug the unit and plug it back in. If error repeats, call for service. ES- Temperature sensor error-- Unplug the unit and plug it back in. If error repeats, call for service. P2- Bucket is full or bucket is not in right position-- Empty the bucket and replace it in the right position. P1- Unit has frost build up-- Allow the unit to run on AUTO DEFROST mode. EC- Unit malfuction--Please make sure whether the environment temperature is suitable for the stated temperature in the manual or not. If not, please operate the unit under the stated temperature. If the environment temperature is normal for the stated temperature, please call for service. Other features Bucket Full Light Glows when the bucket is ready to be emptied, or when the bucket is removed or not placed in the proper position. Auto Shut Off The dehumidifier shuts off after 30 seconds when the bucket is full, or when the bucket is removed or not placed in the proper position.When the set humidity is reached, the unit will shut off automatically. For some models,the fan motor will continue operating. Auto Defrost When frost builds up on the evaporator coils, the compressor will cycle off and the fan will continue to run until the frost disappears. Wait 3 minutes before resuming operation After the unit has stopped, it can not be restarted immediately. This is to protect the unit from malfunction. Operation will automatically start after 3 minutes. Check filter feature The system starts to count the time once the fan motor operates. The check filter feature will be lit when the accumulated operation time achieves 250 hours or more. The Reset light(Clean filter indicator light) flashes until the filter is cleaned. Press the Filter button to reset and stop the blinking filter and Reset light(Clean filter indicator light). Auto-Restart If the unit shuts off unexpectedly due to a power outage, it will restart automatically with the previous function setting when the power resumes. Setting the Timer When the unit is on, first press the TIMER button, the TIMER OFF indicator light illuminates. It indicates the Auto Stop program is initiated. Press it again for the TIMER ON indicator light to come on to indicate the Auto Start is initiated. When the unit is off, first press the Timer button for the TIMER ON indicator light to come on to indicate the Auto Start program. Press again to stop the Timer and initiate Auto Stop. Press or hold the UP or DOWN buttons to change the Auto timer by half hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until the start time. The selected time will register in 5 seconds and the system will automatically revert back to display the previous humidity setting. When the Auto start & Auto stop times are set, within the same program sequence, TIMER ON OFF indicator lights both turn on to show that the TIMER ON and OFF program is active. Turning the unit ON or OFF at any time or adjusting the timer setting to 0.0 will cancel the Auto Start/Stop function. When LED display window displays the code P2, the Auto Start/Stop function will also be cancelled. 5 Parts identification Front 1 Control panel 2 Air intake grille 3 Air outlet grille 4 Air filter (behind the grille) 5 Water bucket 6 Handle (both sides) Dehumidifier Capacity Water TankVolume 30 / 40 pints 6.3 pints 60 pints 12.7 pints PARTS IDENTIFICATION 1 6 2 3 4 5 Fig.2 Rear 1 Drain hose outlet 2 Caster wheels 1 3 Power Cord and plug 4 Band(Used only when storing the unit.) NOTE: All pictures in the manual are for 2 explanation purposes only.The actual 3 design of your unit may be slightly different, but the operations and functions are the same. Fig.3 Accessories: Drain hose(1pc) Screw(2pc) Adapter A(1pc) 6