Magnavox MS3252S User manual, English (US) - Page 30

REMOTE USE WITH ACCESSORY DEVICES - SEARCH METHOD SEARCH METHOD Your TV remote can be set to work various external devices such as VCRs, Cable Boxes, Satellite Receivers, DBS, DVD Players, etc., by using the search method of remote control programming. If the Code Entry method shown on the previous page did not set your remote to work your external device, then follow the easy steps listed below. Please read steps 1-4 before beginning. 1 Press the POWER button on the accessory device to turn it ON. 2 Place the TV/VCR/ACC Mode Switch in the proper position for the device you want to operate. 3 Press and hold the A/CH • RECORD and SMART SOUND buttons simultaneously. 4 The device will begin to change channels after the remote identifies the correct code. When the channels start to change, release the A/CH • RECORD and SMART SOUND buttons. The remote should be ready to operate the device. Satellite Receiver 1 Cable Converter VCR 070809 06 06 070809 070809 2 SLEEP POWER A/CH STATUS/EXIT CC CLOCK TV RECORD 1 VCR 2 ACC 45 TV/VCR 3 6 7 SMART SOUND MENU 8 0 39 SMART PICTURE SURF 4 HELPFUL HINT This method can take up to two minutes to perform. Don't let the device scan up more than five channels. If you do, the remote may pass up the right code and another two minute search cycle will have to be repeated. If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work the desired device. 3 VOL CH MUTE NOTE: The remote is for use with external accessory devices only and not for use with other brands of TVs. 30