Makita GA5093 Instruction Manual - Page 12
guard for grinding
View all Makita GA5093 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Installing wire wheel brush Optional accessory CAUTION: Do not use wire wheel brush that is damaged, or which is out of balance. Use of damaged wire wheel brush could increase potential for injury from contact with broken wires. CAUTION: ALWAYS use guard with wire wheel brushes, assuring diameter of wheel fits inside guard. Wheel can shatter during use and guard helps to reduce chances of personal injury. Place the tool upside down to allow easy access to the spindle. Remove any accessories on spindle. Thread wire wheel brush onto spindle and tighten with the wrenches. 1 Installing dust collecting wheel guard for grinding Optional accessory With optional accessories, you can use this tool for planing concrete surface. CAUTION: Dust collecting wheel guard for grinding is only for use in planing concrete surface with a cup-type diamond wheel. Do not use this guard with any other cutting accessory or for any other purpose. CAUTION: Before operation, make sure that a vacuum cleaner is connected to the tool and turned on. Place the tool upside down and install the dust collecting wheel guard. Mount the inner flange onto the spindle. Fit the cup-type diamond wheel on the inner flange and tighten the lock nut onto the spindle. 1 3 2 4 Fig.18 ► 1 . Wire wheel brush Installing hole cutter Optional accessory Place the tool upside down to allow easy access to the spindle. Remove any accessories on the spindle. Thread the hole cutter onto the spindle, and tighten it with the supplied wrench. 1 5 6 Fig.20 ► 1 . Lock nut 2. Cup-type diamond wheel 3. Hubbed cup-type diamond wheel 4. Inner flange 5. Dust collecting wheel guard 6. Bearing box NOTE: For information how to install the dust collecting wheel guard, refer to the manual of the dust collecting wheel guard. Fig.19 ► 1 . Hole cutter 12 ENGLISH