Makita XAG26Z XAG26 Instruction Manual - Page 11
For depressed center wheel, flap, off wheel, diamond wheel, wheel or flap disc
View all Makita XAG26Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
For depressed center wheel, flap disc, wire wheel brush / abrasive cutoff wheel, diamond wheel 1. While pushing the lock lever, mount the wheel guard with the protrusions on the wheel guard aligned with the notches on the bearing box. NOTE: Push down the wheel guard straight. Otherwise, you cannot push the wheel guard completely. 3. While keeping the lock lever and wheel guard position as described in step 2, rotate the wheel guard toward C, and then, change the angle of the wheel guard according to the work. B C B 3 A 1 2 B C ► 1 . Lock lever 2. Notch 3. Protrusion 2. While pushing the lock lever toward A, push in the wheel guard by holding down the portions B as shown in the figure. B B A 1 2 ► 1 . Wheel guard 2. Hole NOTE: Push the wheel guard completely. Otherwise, you cannot rotate the wheel guard. To remove wheel guard, follow the installation procedure in reverse. When using a depressed center wheel or flap disc Optional accessory WARNING: When using a depressed center wheel or a flap disc, the wheel guard must be fitted on the tool so that the closed side of the guard always points toward the operator. 1 2 ► 1 . Wheel guard 2. Hole 1 2 ► 1 . Depressed center wheel 2. Wheel guard 11 ENGLISH