Makita XAG26Z XAG26 Instruction Manual - Page 13

1. To install the X-LOCK wheel, make sure that both catches are in the unlocked position. If not, push the release lever from A side to lift B side, then pull the release lever from B side as illustrated. The catches are set in the unlocked position. 4. Make sure the X-LOCK wheel is fixed correctly. The surface of the X-LOCK wheel is no higher than the surface of the holder as shown in the figure. If not, the holder must be cleaned or the X-LOCK wheel must not be used. 1 2 A 1 2 ► 1 . Surface of the holder 2. Surface of the X-LOCK wheel B To remove the X-LOCK wheel, push the release lever from A side to lift B side, then pull the release lever from B side as illustrated. The X-LOCK wheel is released and can be removed. ► 1 . Catch 2. Release lever 2. Place a central position of the X-LOCK wheel on the holder. Make sure the X-LOCK wheel is parallel to the flange surface and with the correct side facing up. 3. Push the X-LOCK wheel into the holder. The A catches snap into the lock position with a click and fix the X-LOCK wheel. B 1 1 ► 1 . Release lever 2 3 4 ► 1 . X-LOCK wheel 2. Holder 3. Flange surface 4. Catch OPERATION WARNING: It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. WARNING: ALWAYS replace wheel if tool is dropped while grinding. WARNING: NEVER hit the workpiece with the wheel. WARNING: Avoid bouncing and snagging the wheel, especially when working corners, sharp edges etc. This can cause loss of control and kickback. WARNING: NEVER use tool with wood cutting blades and other saw blades. Such blades when used on a grinder frequently kick and cause loss of control leading to personal injury. WARNING: Never actuate the release lever of the X-LOCK holder during operation. The X-LOCK wheel comes off from the tool and may cause serious injury. WARNING: Make sure that the X-LOCK wheel is fixed firmly. 13 ENGLISH