Makita XCM01Z Instruction Manual - Page 13
Removing dust collection cover
View all Makita XCM01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3. Raise the tool handle slightly and place the front half of the wheel guard at an angle into the dust collection cover, throwing the bottom of the cutting wheel down through the wheel slot in the base. 5. Raise the tool handle again to hook the rear edge of the wheel guard over the stopper inside the dust collection cover. 2 1 1 2 3 Fig.19 4 ► 1 . Wheel guard 2. Dust collection cover 3. Cutting wheel 4. Wheel slot 4. Install the rear half of the wheel guard in the dust collection cover, while lowering the tool handle from a raised position to a down position. 1 2 Fig.21 ► 1 . Wheel guard 2. Stopper 6. Loosen the thumb screw. Swing the tool up and down at your desired cutting depth. Then tighten the thumb screw to secure the tool in place. Removing dust collection cover 1. Loosen the thumb screw on the depth scale of the dust collection cover. Lift the tool handle fully up, and then tighten the thumb screw to secure the dust collection cover in a raised position. 3 1 2 Fig.20 ► 1 . Wheel guard 2. Dust collection cover Fig.22 ► 1 . Thumb screw 2. Depth scale 3. Dust collection cover 13 ENGLISH