Makita XCU07PT XCU07 Instruction Manual - Page 10
Assembly
View all Makita XCU07PT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
1 2 Checking the run-down brake CAUTION: If the saw chain does not stop within one second in this test, stop using the chain saw and consult our authorized service center. Run the chain saw then release the switch trigger completely. The saw chain must come to a standstill within one second. Adjusting the chain lubrication ► 1 . Switch trigger 2. Lock-off lever Checking the chain brake You can adjust the oil pump feed rate with the adjusting screw. The amount of oil can be adjusted using the universal wrench. CAUTION: Hold the chain saw with both hands when switching it on. Hold the rear handle with your right hand, the front handle with your left. The bar and the chain must not be in contact with any object. CAUTION: Should the saw chain not stop immediately when this test is performed, the saw may not be used under any circumstances. Consult our authorized service center. 1. Press the lock-off lever, then pull the switch trigger. The saw chain starts immediately. 2. Push the front hand guard forwards with the back of your hand. Make sure that the chain saw comes to an immediate standstill. 2 3 1 1 ► 1 . Adjusting screw ASSEMBLY CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. CAUTION: Do not touch the saw chain with bare hands. Always wear gloves when handling the saw chain. Removing or installing saw chain 2 1 CAUTION: The saw chain and the guide bar 3 are still hot just after the operation. Let them cool down enough before carrying out any work on the tool. To remove the saw chain, perform the following steps: 1. Release the chain brake by pulling the front hand guard. ► 1 . Front hand guard 2. Unlocked position 3. Locked position 10 ENGLISH