Makita XCU07PT XCU07 Instruction Manual - Page 9

Capacity indicator status On Off Blinking Remaining battery capacity 50% to 100% 20% to 50% Main power switch WARNING: Always turn off the main power switch when not in use. To stand by the chain saw, press the main power switch until the main power lamp lights up. To turn off, press the main power switch again. 1 0% to 20% Charge the battery Indicating the remaining battery capacity Only for battery cartridges with the indicator ► 1 . Main power switch NOTE: The main power lamp brinks if the switch trigger is pulled under unoperatable conditions. The lamp blinks if you 1 • turn on the main power switch while holding down the lock-off lever and the switch trigger; • pull the switch trigger while the chain brake is applied; • release the chain brake while holding down the 2 lock-off lever and pulling the switch trigger. ► 1 . Indicator lamps 2. Check button Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light up for a few seconds. Indicator lamps Remaining capacity Lighted Off Blinking 75% to 100% 50% to 75% 25% to 50% 0% to 25% Charge the battery. The battery may have malfunctioned. NOTE: This chain saw employs the auto power-off function. To avoid unintentional start up, the main power switch will automatically shut down when the switch trigger is not pulled for a certain period after the main power switch is turned on. Switch action WARNING: For your safety, this tool is equipped with lock-off lever which prevents the tool from unintended starting. NEVER use the tool if it runs when you simply pull the switch trigger without pressing the lock-off lever. Return the tool to our authorized service center for proper repairs BEFORE further usage. WARNING: NEVER tape down or defeat purpose and function of lock-off lever. CAUTION: Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. NOTICE: Do not pull the switch trigger hard without pressing the lock-off lever. This can cause switch breakage. NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. To prevent the switch trigger from being accidentally pulled, a lock-off lever is provided. To start the tool, depress the lock-off lever and pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. 9 ENGLISH