Makita XCU08PT XCU08 XCU09 Instruction Manual - Page 13

Checking the run-down brake, Adjusting the chain lubrication, Carabiner rope attachment point,

Get Makita XCU08PT PDF manuals and user guides View all Makita XCU08PT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

2. Push the front hand guard forwards with the back of your hand. Make sure that the chain saw comes to an immediate standstill. 3 2 1 Adjusting the chain lubrication You can adjust the oil pump feed rate with the adjusting screw using the universal wrench. The amount of oil can be adjusted in 3 steps. Open the cap to adjust the adjusting screw. 1 2 2 3 ► 1 . Front hand guard 2. Unlocked position 3. Locked position Checking the run-down brake CAUTION: If the saw chain does not stop within two seconds in this test, stop using the chain saw and consult our authorized service center. Run the chain saw then release the switch trigger completely. The saw chain must come to a standstill within two seconds. ► 1 . Cap 2. Adjusting screw Carabiner (rope attachment point) You can hang the tool by attaching the rope to the carabiner. Pull up the carabiner, and then tie it with the rope. 1 ► 1 . Carabiner Electronic function The tool is equipped with the electronic functions for easy operation. • Soft start The soft-start function minimizes start-up shock, and makes the tool start smoothly. 13 ENGLISH

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
13
ENGLISH
2.
Push the front hand guard forwards with the
back of your hand. Make sure that the chain saw
comes to an immediate standstill.
1
2
3
2
3
►
1.
Front hand guard
2.
Unlocked position
3.
Locked position
Checking the run-down brake
CAUTION:
If the saw chain does not stop
within two seconds in this test, stop using
the chain saw and consult our authorized
service center.
Run the chain saw then release the switch trig-
ger completely. The saw chain must come to a
standstill within two seconds.
Adjusting the chain lubrication
You can adjust the oil pump feed rate with the
adjusting screw using the universal wrench. The
amount of oil can be adjusted in 3 steps. Open
the cap to adjust the adjusting screw.
1
2
►
1.
Cap
2.
Adjusting screw
Carabiner (rope attachment point)
You can hang the tool by attaching the rope to
the carabiner. Pull up the carabiner, and then tie
it with the rope.
1
►
1.
Carabiner
Electronic function
The tool is equipped with the electronic functions
for easy operation.
•
Soft start
The soft-start function minimizes start-up
shock, and makes the tool start smoothly.