Makita XCU08PT XCU08 XCU09 Instruction Manual - Page 21
Storing the tool, Instructions for periodic maintenance
View all Makita XCU08PT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Always fit a new locking ring when replacing the sprocket. 2 1 ► 1 . Locking ring 2. Sprocket NOTICE: Make sure that the sprocket is installed as shown in the figure. Storing the tool 1. Clean the tool before storing. Remove any chips and sawdust from the tool after removing the sprocket cover. 2. After cleaning the tool, run it under no load to lubricate the saw chain and guide bar. 3. Cover the guide bar with the guide bar cover. 4. Empty the oil tank. Instructions for periodic maintenance To ensure long life, prevent damage and ensure the full functioning of the safety features, the following maintenance must be performed regularly. Warranty claims can be recognized only if this work is performed regularly and properly. Failure to perform the prescribed maintenance work can lead to accidents! The user of the chain saw must not perform maintenance work which is not described in the instruction manual. All such work must be carried out by our authorized service center. Check item / Operating Before time operation Chain saw Inspection. Everyday - Every week - Every 3 month - Annually - Before storage - Cleaning. - - - - - Check at - - - - authorized service center. Saw chain Inspection. - - - - - Sharpening - - - - - if necessary. Guide bar Inspection. - - - - Remove - - - - - from the chain saw. Chain brake Check the function. - - - - - Have it - - - inspected regularly at authorized service center. - - Chain Check the lubrication oil feed rate. - - - - - Switch trigger Inspection. - - - - - Lock-off lever Inspection. - - - - - 21 ENGLISH