Makita XLC03ZBX4 XLC03 Instruction Manual - Page 9

NOTICE: Always be sure to check that high performance filter is loaded correctly prior to using cleaner. If they are not loaded correctly, dust will get into the motor housing, and cause motor failure. If the problem as described later occurs, high performance filter is not loaded correctly. Reload them correctly to rectify problem. Attach the capsule. Align the mark on capsule with the mark on the handle and then firmly twist capsule in the direction of arrow until it is secured. 1 2 3 Installing or removing stay / HEPA filter Optional accessory For the stay and sponge filter To remove the stay, push up the bottom part of pillars of the stay with your fingers and release its groove from the protrusion on the cleaner. After that, remove the sponge filter. 1 2 ► 1 . Mark 2. Handle 3. Capsule NOTE: Always remove dust ahead of time, as suction power will be reduced if there is too much dust in cleaner. Problem Examples The securing lip of high performance filter is not firmly locked into groove of cleaner housing. 2 ► 1 . Stay 2. Sponge filter To install, align the grooves on the stay with the protrusion on the cleaner and push until it clicks. Insert the sponge filter between the pillars and set it in the original position. For the HEPA filter When installing the HEPA filter, fit the groove of the HEPA filter with the protrusion on the cleaner. Then, put the prefilter or the high performance filter on the HEPA filter and twist it to secure. To remove, follow the installation procedure in reverse. 1 1 ► 1 . Securing lip 2. Groove of cleaner housing 2 ► 1 . HEPA filter 2. Prefilter 9 ENGLISH