Makita XRU02Z Instruction Manual - Page 10

Failure to switch off the tool and remove the battery cartridge may cause a personal injury. CAUTION: • While installing or removing the Nylon cutting head, be careful not to contact the nylon cord cutter provided on the guard. Contact with the cutter could result in personal injury. WARNING: • Use only 1.65 mm (1/16") diameter nylon cord. Never use metal wire, rope or the like. Use of something other than the recommended nylon cord may cause damage to the trimmer and result in serious personal injury. Winding a new Nylon cord on the spool 012412 Remove the spool from the spool cover and take off the remaining used Nylon cord from the spool. 1. Nylon cord 2. Retainer for 2 nylon cord end 1 012408 012413 Insert a Nylon cord to the retainer shown in the figure. 012409 To remove the Nylon cutting head (spool and spool cover) from the string trimmer, press in the latches forcefully on both sides of the spool cover and raise it. 1 2 1. Nylon cord eyehole 2. Notch of the nylon cutting head installation 3 port 3. Spring 4. Spool holder 4 012440 NOTICE: • Make sure that the spring is installed inside the spool holder. To install a cord-newly-wound Nylon cutting head (spool and spool cover) on the string trimmer, align the Nylon cord eyehole with the notch of the Nylon cutting head installation port on the trimmer and then press in it until a click is heard. 012414 Wind it tightly flat around the spool in the direction of arrow on the spool so that the wound Nylon cord surface appears uniform over the winding area. 012415 Temporarily fix a Nylon cord at the notch shown in the figure. 10