Makita XRU02Z Instruction Manual - Page 4

Method of operation 1. Only use the tool in good light and visibility. During the winter season beware of slippery or wet areas, ice and snow (risk of slipping). Always ensure a safe footing. 2. Take care against injury to feet and hands from the nylon cutting head. 3. Never cut above waist height. 4. Never stand on a ladder and run the tool. 5. Never climb up into trees to perform cutting operation with the tool. 6. Never work on unstable surfaces. 7. Remove sand, stones, nails etc. found within the working range. Foreign particles may damage the nylon cutting head. 8. Should the nylon cutting head hit stones or other hard objects, immediately switch off the motor and inspect the nylon cutting head. 9. Before commencing cutting, the nylon cutting head must have reached full working speed. 10. During operation always hold the tool with both hands. Never hold the tool with one hand during use. Always ensure a safe footing. 11. The nylon cutting head has to be equipped with the guard. Never run the tool with damaged guards or without guards in place! 12. All protective equipment such as guards supplied with the string trimmer must be used during operation. 13. Except in case of emergency, never drop or cast the tool to the ground or this may severely damage the tool. 14. Never drag the tool on the ground when moving from place to place, the tool may become damaged if moved in this manner. 15. Always remove the battery cartridge from the tool: − whenever leaving the tool unattended; − before clearing a blockage; − before checking, cleaning or working on the tool; − whenever the tool starts vibrating abnormally; − whenever transporting the tool. 16. Always ensure that the ventilation openings are kept clear of debris. Maintenance instructions 1. The condition of the nylon cutting head, protective devices must be checked before commencing work. 2. Turn off the motor and remove the battery cartridge before carrying out maintenance, replacing the nylon cutting head or nylon cord and cleaning the tool. 3. Check for loose fasteners and damaged parts such as cracks in the nylon cutting head. 4. Follow instructions for lubricating and changing accessories if applicable. 5. When not in use store the equipment in a dry location that is locked up or out of children's reach. 6. Use only the manufacturer's recommended replacement parts and accessories. 7. Inspect and maintain the tool regularly, especially before/after use. Have the tool repaired only by our authorized service center. 8. Keep handles dry, clean and free from oil and grease. SAVE THESE INSTRUCTIONS. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. USG001-2 WARNING: Use of this product can create dust containing chemicals which may cause respiratory or other illnesses. Some examples of these chemicals are compounds found in pesticides, insecticides, fertilizers and herbicides. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. USD301-4 Symbols The followings show the symbols used for tool. ･ volts ･ direct current ･ rated speed ･ no load speed ･ revolutions or reciprocation per minute 4