Makita XTP02Z XTP02 Instruction Manual - Page 6

Indicator lamps Remaining capacity Lighted Off Blinking Charge the battery. The battery may have malfunctioned. Trigger-lock button CAUTION: Before installing the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. CAUTION: When not operating the tool, depress the trigger-lock button from B side to lock the switch trigger in the OFF position. NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. Indicating the remaining battery capacity Country specific When you either pull the switch trigger or push the contact element, the battery indicator shows the remaining battery capacity. 1 1 2 ► 1 . Trigger-lock button 2. Switch trigger B ► 1 . Battery indicator The remaining battery capacity is shown as the following table. Battery indicator status On Off Blinking Remaining battery capacity 50% to 100% 20% to 50% 0% to 20% Charge the battery A To prevent the switch trigger from accidentally pulled, the trigger-lock button is provided. To pull the switch trigger, depress the trigger-lock button from A side. After use, always press in the trigger-lock button from B side. Adjusting the depth of pin-nailing WARNING: Always make sure that your fingers are not placed on the switch trigger or the contact element and the battery cartridge is removed before adjusting the depth of nailing. Depth of pin-nailing can be adjusted on this pin nailer. To adjust the depth of nailing, turn the adjuster. The depth of nailing is the deepest when the adjuster is turned fully in the A direction shown in the figure. It will become shallower as the adjuster is turned in the B direction. Depth can be adjusted 1.5 mm to the maximum. 6 ENGLISH