Makita XTP02Z XTP02 Instruction Manual - Page 9
Driving pin nails, Checking remaining pin nails
View all Makita XTP02Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Test safety systems for possible fault before operation as follows. 1. Unload pin nails from the tool and keep the magazine opened. 2. Install the battery cartridge and release the trigger lock. 3. Only pull the switch trigger without touching the contact element against the material. 4. Only touch the contact element against the material without pulling the switch trigger. If the tool operates in the case of 3 and 4 above, the safety systems are faulty. Stop using the tool immediately and ask your local service center. Driving pin nails WARNING: Continue to place the contact element firmly on the material until the pin nail is driven completely. Unintentional firing may cause personal injuries. 1. Release the trigger lock. 2. Place flat the contact element on the material. 3. Pull the switch trigger fully to drive a pin nail. 4. To drive the next pin nail, release your finger from the switch trigger once, and then repeat the step 2 and 3 above. 1 2 ► 1 . Switch trigger 2. Contact element You can also drive the pin nails when dragging the tool to the next area with the contact element pressed against the material and pulling the switch trigger. NOTE: If the head of the pin nail still remains above the workpiece even you hold the pin nail head, the material may not be suitable for the pin nailer. Continuing to use the pin nailer on such material may result in a damage to the driver of the pin nailer and/ or pin nailer jamming. Anti dry fire mechanism WARNING: Always make sure that your fingers are not placed on the switch trigger or the contact element and the battery cartridge is removed before loading the pin nailer. When the number of remaining pin nails in the magazine are 0 - 3 pieces, the switch trigger can no longer be pulled. At this time, insert a new strip of pin nails in the magazine and the switch trigger can be pulled again. NOTE: When firing a different length of pin nails shortly after the anti-dry firing device has actuated, insert a new strip of pin nails into the magazine and fire away all the prior pin nails that have remained on junk material. Checking remaining pin nails You can check the amount of remaining pin nails through the sight window. The red indicator moves toward fastening opening with the amount of remaining pin nails become smaller. 1 2 ► 1 . Sight window 2. Indicator If the head of the pin nail remains above the workpiece surface, drive the pin nail while holding the pin nailer head firmly against the workpiece. 9 ENGLISH